User manual PANASONIC WV-7160D

[. . . ] Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1965 The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the bottom of the unit. You should note the serial number of this unit in the space provided and retain this book as a permanent record of your purchase to aid identification in the event of theft. WV-7160D SA 1966 WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. 2 PREFACE The WV-7160D System Controller, when combined with the optional WJ-SX550B Matrix Switcher and WJ-AD550 Extension Unit, allows for flexible control of 128 cameras and 16 monitors. [. . . ] · Do not attempt to disassemble the appliance. To prevent electric shock, do not remove screws or covers. There are no user-serviceable parts inside. Contact qualified service personnel for maintenance. · Handle the appliance with care. Do not strike or shake it, as this may damage the appliance. · Do not expose the appliance to water or moisture, nor try to operate it in wet areas. Take immediate action if the appliance becomes wet. Turn the power off and refer servicing to qualified service personnel. Moisture may damage the appliance and also cause electric shock. · Do not use strong or abrasive detergents when cleaning the appliance body. SET: This key, in combination with the Numeric keys, is used to enter numeric input, such as operator ID and password. It is also used to execute the currently highlighted selection and to enter a submenu in the Setup Menu of the Matrix Switcher. !2 Numeric Keys (0 - 9) These keys are used for numeric input into the system, such as the camera and monitor number, sequence number, preset position, etc. !3 Monitor (Escape) Key [MON (ESC)] MON: This key is used to select a monitor. To select a monitor, press the corresponding Numeric keys, followed by the MON key. ESC: This key is used to escape from the currently highlighted selection on the Setup Menu of the Matrix Switcher. Pressing this key, while the Alternate (ALT) indicator is on, will display the video that is connected to the Monitor Input (MONITOR IN) Connector on the WVPB5504 Video Output Board. !4 Stop/Slow Button (STOP/SLOW) STOP: Pauses a sequence that is being run on the active monitor. SLOW: For fine pan/tilt control, move the joystick while holding down the SLOW button. !5 Increment Button (INC +1CAM) When a sequence running in forward direction has been paused with the Stop button, pressing this button will move the sequence one frame to the next step (in forward run direction). If the sequence was running in reverse direction, the button will move the sequence one frame to the next step (in reverse run direction). [. . . ] @1 Alarm Acknowledge and Reset Button (ACK RESET) This button cancels an activated alarm. To cancel an alarm, first select the alarmed monitor(s), then press the ACK RESET button once for alarm acknowledgment (the indicator on the button blinks rapidly), and finally press it again for alarm reset (the indicator goes off). After an alarm acknowledgment, pressing this button while the Alternate (ALT) indicator is on will cancel all currently activated alarms at the same time. #1 Data Ports (DATA IN, OUT) Exchanges control data with the WJ-SX550B Matrix Switcher in a system. [. . . ]