User manual PANASONIC WV-7360

[. . . ] Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amp and that it is approved by ASTA or BSI to BS1362. or the BSI mark on the body of the Check for the ASTA mark fuse. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. [. . . ] IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal in the plug which is marked with the letter L or coloured red. How to replace the fuse Open the fuse compartment with a screwdriver and replace the fuse and fuse cover. WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CONTENTS PREFACE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 MAJOR OPERATING COMPONENTS AND THEIR FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 CONNECTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . This action could damage the appliance permanently. Turn the power off immediately and refer servicing to qualified service personnel. · Use the appliance under conditions where temperatures are within ­10°C - +50°C (14°F - 122°F, ) and humidity is below 90%. The input power source is 220 240 V AC 50 Hz. Do not operate the appliance in an extreme environment where is out of its specified temperature or humidity range, or power source ratings. -1- ENGLISH MAJOR OPERATING COMPONENTS AND THEIR FUNCTIONS POWER ON OFF Camera Drive Unit WV-PS104 C CAMERA IN 4ch VIDEO OUT AUDIO OUT CAMERA IN 3ch VIDEO OUT AUDIO OUT CAMERA IN 2ch VIDEO OUT AUDIO OUT CAMERA IN 1ch VIDEO OUT AUDIO OUT VD/SYNC IN VD/SYNC OUT (4V[p-p] 75W) SIGNAL GND q Power On/Off Switch (POWER, ON/OFF) This switch is used to turn the camera drive unit and connected specified camera power on or off. The indicator lights up when the power of the camera drive unit is on. w Cooling Fan Unit This unit prevents the temperature of the camera drive unit from rising Caution: Do not block the ventilation opening or slots on the cover to prevent the temperature of the camera drive unit from rising. The power indicator blinks to indicate an unusual temperature rise. Do take immediate action when the power indicator blinks. Turn the power off and refer servicing to qualified service personnel. e Camera Input Connector (CAMERA IN) This connector receives either a colour or B/W composite video signal from the specified camera. [. . . ] Install the camera drive unit with the rack mounting brackets in the rack by using four screws (not supplied. ) Cautions: · Do not block the ventilation opening or slots on the cover to prevent the appliance temperature from rising. Always keep the temperature in the rack within 50 °C (122 °F). · Fix the rear of the appliance on the rack by using an additional mounting bracket (not supplied) if the appliance is exposed to vibration. -3- CONNECTIONS Cautions: · Set the POWER switch of the camera drive unit to OFF (l) during connections. If the power of the camera drive unit is ON during connections, the protection circuit that protects it in case of wrong connection will operate and prevent the camera from functioning. [. . . ]