User manual PANASONIC WV-BL730

[. . . ] CCTV Cameras WV-BLR730/WV-BLR734 ENGLISH (Lens : option) Before attempting to connect or operate this product, please read these instructions completely. FRANÇAIS ENGLISH VERSION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or coloured black. [. . . ] PARITY CHECK This item is used to select the parity for the RS485 communication. Move the cursor to the PARITY CHECK parameter. STOP BIT This item is used to select the stop bit for the RS485 communication. Move the cursor to the STOP BIT parameter. Select the stop bits and press . UNIT NUMBER This item is used to select the camera number that is used with RS485 communication. Move the cursor to the parameter of UNIT NUMBER. Select the camera number to be used with RS485 communication and press . -21- X ON/X OFF This item is used to select applying the flow control or not. Move the cursor to the X ON/X OFF parameter. Select NOT USE (not apply flow control) or USE (apply flow control) and press . WAIT TIME This item is used to select the wait time to re-transmit after confirming that no data is received from the controller. Move the cursor to the WAIT TIME parameter. When no transmission is needed, select OFF. ALARM DATA This item is used to select the way of transmitting the alarm data. Move the cursor to the ALARM DATA parameter. Select the alarm data transmission mode from following parameters: POLLING: Transmit the alarm data to the controller to request from the controller. AUTO 1: Transmit the alarm data each time the alarm signal is received. AUTO 2: Transmit the alarm data five seconds each. -22- DELAY TIME This item is used to select the time to transmit the acknowledge request when communicating on a twoline connection. Move the cursor to the DELAY TIME parameter. Note: This item appears only when a two-line connection is used. · Installation of Software for RS485 Communication 1. Insert the Install Disk 1 to the C drive of your PC. When the window that says "Please insert the disk labeled: "Disk 2" into drive C:" appears on the monitor screen, insert the Install Disk 2 and press . [. . . ] Move the cursor to the LENS DRIVE parameter. Select DC if you are using the auto iris lens that requires a DC drive signal. Select VIDEO if you are using the auto iris lens that requires a video drive signal. -34- 9. Special Menu (SPECIAL) This menu lets you adjust and setup the video signal of the camera to meet your requirements. [. . . ]