User manual PANASONIC WV-BLR734

[. . . ] If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. H G The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] · Line-locked Sync or switchable Multiplexed Vertical Drive (VD2) automatically. -3- PRECAUTIONS · Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or cover. There are no user-serviceable parts inside. Refer servicing to qualified service personnel. The camera could be damaged by improper handling or storage. · Do not expose the camera to rain or moisture, or try to operate it in wet areas. Do take immediate action if ever the camera do becomes wet. Turn power off and refer servicing to qualified service personnel. Moisture can damage the camera and also create the danger of electric shock. · Never face the camera toward the sun. Whether the camera is in use or not, never face it toward the sun. Under certain unique lighting conditions, the following may appear : · Strong smear and/or blooming on high light objects such as spot lights or windows. · Noticeable flicker on the picture. Should these phenomena occur, use an ALC lens 3. When using in the ELC mode with a fixed iris lens, the depth of field of the image may be less than that obtained by using an ALC lens. Depth of field varies inversely with the iris opening. Thus, using this camera in the ELC mode with the fixed iris lens fully opened will result in less depth of field than if an ALC lens was used. (And distant objects in the picture might not be in focus). -7- CONNECTIONS Power Source s WV-BLR734 Connect the AC Power Cord to a electrical outlet of 220V - 240V AC 50 Hz. A power supply of 24V AC 50 Hz is required. Connect the power cable to the 24V AC In Terminal on the rear panel of the camera. Video Cable 1. It is recommended to use a video monitor whose resolution is at least equal to the camera's. Terminate the camera output with 75 resistor at the furthest end of its cable run. [. . . ] Mounting the Lens When you use the lens other than listed on pages 10, 11, 12 and 13, lens mount should be C-mount or special C-mount (CS-mount 1"-32UN) and lens weight should be less than 450g (0. 99 lbs. ). If not, both the lens and camera should be secured. The protrusion of the rear of the lens should be as shown below. Caution: Always set the Flange-back adjusting ring to fully clockwise (C-mount side) by loosing screws on the ring before mounting the lens, otherwise the inner glass and CCD image sensor could be damaged by the lens. (1) Mount the lens by turning it clockwise onto the lens mount of the camera. [. . . ]