User manual PANASONIC WV-BP110

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1966 The serial number of this product may be found on the surface of the unit. [. . . ] Otherwise, it may cause malfunction or damage data recorded on the SD memory card. Refer to page 16 for descriptions of how to insert/ remove an SD memory card. 8 · When using an unformatted SD memory card, format it using this camera. Recorded data on the SD memory card will be deleted when formatted. If using an unformatted SD memory card or using an SD card formatted with other device, the camera may not work properly or performance deterioration may be caused. Refer to the Network Operating Instructions (PDF) for descriptions of how to format an SD memory card. · It is recommended to use Panasonic's SD memory card. Otherwise, the camera may not work properly or performance deterioration may be caused. · Images saved on the SD memory card may lead to personal information leakage. When it is necessary to give the camera to someone, even when for repair, make sure the SD memory card is removed from the camera. Do not aim the camera at strong light sources. A light source such as a spot light causes a blooming (light bleeding) or a smear (vertical lines). Smear Blight subject Do not strike or shake, as this may damage the appliance. Notes: · The following are descriptions of how to adjust a normal varifocal lens. For further information, refer to the operating instructions of the lens in use. Focus on a subject which is located around 10 m away or farther to adjust the flange-back length. When using an 8x or 10x varifocal lens, adjust the flange-back length after setting the zoom to the WIDE end and settings the focus to the FAR end. When using a 2x or 3x varifocal lens, adjust the flange-back length after setting the zoom to the TELE end and settings the focus to the FAR end. Locate a subject at the center and roughly adjust the angular field of view and the focus by adjusting the zoom position and the focus position. Then, adjust the flange-back length minutely. ( page 17) · When the lens in use is not Panasonic's and whose focus range is scalable, adjust the flange-back length after setting the focus position to one step short of the FAR end in step 2. When adjusting the focus in the scalable range, focus may not be adjusted appropriately. How to use a fixed-focus lens When using a fixed-focus lens featured the focus adjustment, adjust the flange-back length after setting the lens focus to the FAR end. When using a manual lens When using a manual lens, fit the provided connector cap into the ALC lens connector as shown in the illustrations below. (The tab of the connector cap should be toward the lens. ) Connector cap ALC lens connector Manual lens Fitted connector cap Tab 12 Installations/Connections Before start the installation/connection, prepare the required devices and cables. Before starting the connection, turn the power of the devices including the camera and the PC off or disconnect the power cable from the outlet. Step 1 Fix an optional camera mounting bracket onto the desired place and mount the camera on it. [. . . ] When the Panasonic IP setting software does not work to perform the network settings of the camera, perform the network settings of the camera and the PC individually on the "Network setup" page of the setup menu. Refer to the Network Operating Instructions (PDF) for further information. Important: · When using Windows XP SP2, the "Windows Security Alert" window may be displayed when starting the IP setting software. In this case, click the "Unblock" button on the displayed "Windows Security Alert" window. [. . . ]