User manual PANASONIC WV-BP312

[. . . ] FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Front / Upper SA 1965 The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the top of the unit. You should note the serial number of this unit in the space provided and retain this instruction as a permanent record of your purchase to aid identification in the event of theft. [. . . ] There are no user-serviceable parts inside. Ask qualified service personnel for servicing. The camera could be damaged by improper handling or storage. Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately and ask qualified service personnel for servicing. Moisture can damage the camera and also create the danger of electric shock. Do not use strong or abrasive detergents when cleaning the camera body. Use a dry cloth to clean the camera when dirty. In case the dirt is hard to remove, use a mild detergent and wipe gently. Afterwards, wipe off the remained part of the detergent in it with a dry cloth. Do not clean the lens with strong or abrasive detergents. · To prevent fire or electric shock hazard, use a UL listed cable (WV-1, style 1007) for the DC 12 V Input Terminal. · Do not mistake "+" and "­" when connecting the power cable to the DC 12 V input terminal of the camera. Connect the power cable and the video cable to the camera. Note: The illustration on the right assumes that you will use a junction box. Pass the cables through the cabIe access hole. If you mount the camera directly on the wall/ceiling, cut out the panel according to the concave. (Refer to the previous page. +12V DC · Calculation of the relation among the cable length, resistance, and power supply: 10. 5 V DC VA - 2(R x 0. 24 x L) 16 V DC L : Cable length (m) R : Resistance of copper wire (/m) VA : DC output voltage of power supply unit Power cable Video cable · Connect them to 12 V DC (10. 5 V to 16 V) class 2 power supply only. · To prevent fire or electric shock hazard, use a UL listed cable (VW-1, style 1007) for the Input Terminal. Adjust the panning, tilting and azimuth while watching the LCD monitor. If the image is slanting, move the azimuth adjuster to obtain a leveled image. Notes: · You can check images by connecting an LCD monitor to the video jack. [. . . ] (2) Adjust the focus by moving the focus lever. (3) Turn the focus lock screw clockwise to tighten the focus level after adjustment. Note: The focus should be adjusted after the adjustments of panning, tilting, azimuth and zoom. After all the adjustments and connections attach the inner dome to the camera. [. . . ]