User manual PANASONIC WV-CF212

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Use lens tissue or a cotton tipped applicator and ethanol. Do not aim the camera at bright objects. Whether the camera is in use or not, never aim it at the sun or other extremely bright objects. Otherwise, blooming or smear may be caused. Do not operate the camera beyond the specified temperature, humidity or power source ratings. Use the camera under conditions where temperature is between ­10 °C to +50 °C (14 °F to 122 °F), and humidity is below 90 %. The input power source is 12 V DC, 240 mA. It is recommended to use a monitor whose resolution is at least equal to that of the camera. Shown figure is an example for junction box. 46 mm (1-13/16") 83, 5 mm (3-5/16") Camera mounting screw x 4 To mount the camera directly on the wall/ceiling 1. Cut out the panel according to the concave. Prepare a space, which is ø155 mm (6. 1") or larger, on the wall/ceiling. Attach the four mounting screws to the wall/ceiling. (Refer to "Installation dimensional drawing". ) 4. Fasten all the mounting screws. 83. 5 mm (3. 29") How to mount the camera 1. Remove the panel screw with a phillips screwdriver. (Refer to the illustration on the right. ) 2. Mount the camera on the junction box or ceiling/wall. (Refer to "Camera mounting position". ) Inner dome 1. Remove the panel screw. CONNECTIONS WARNING The following connections should be made by qualified service personnel or system installers. Cable Preparation Power cable (with sealing at the side of the camera) 20 mm (0. 79") or less 2. Turn the panel cover counter-clockwise. Video Cable Type of coaxial cable Recommended (m) maximum cable length (ft) RG-59/U RG-6U RG-11/U RG-15/U (3C-2V) (5C-2V) (7C-2V) (10C-2V) 250 825 500 1 650 600 1 980 800 2 640 Seal here. 3. Remove the inner dome. Power Cable Connect the power cord to the 12 V DC input terminal. [. . . ] Note: The focus should be adjusted after the adjustments of panning, tilting, azimuth and zoom. After all the adjustments and connections attach the inner dome to the camera. The mark of the panel cover and the projection of the camera panel should be put together. Notes: · Avoid covering the lens with the still part the dome. [. . . ]