User manual PANASONIC WV-CF224EX

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices). [. . . ] To prevent fire or electric shock hazard, use a UL listed cable (VW-1, style 1007) to connect the power supply to the camera. Be sure to use a ceiling board/wall having enough strength to support this camera. Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or covers. There are no user-serviceable parts inside. Ask qualified service personnel for servicing. The camera could be damaged by improper handling or storage. Do not expose the camera to rain or moisture, or try to operate it in wet areas. This product is designed for indoor use or locations where it is protected from rain and moisture. Turn the power off immediately and ask a qualified service personnel for servicing. Moisture can damage the camera and also create the danger of electric shock. Do not use strong or abrasive detergents when cleaning the camera body. Use a dry cloth to clean the camera body when it is dirty. In case the dirt is hard to remove, use a mild detergent and wipe gently. Afterwards, wipe off the remained part of the detergent in it with a dry cloth. Do not clean the lens with strong or abrasive detergents. Use lens tissue or a cotton tipped applicator and ethanol. Front / Upper 46 mm {1-13/16"} 4-ø4. 5 mm {4-ø3/16"} ø135 mm {5-5/16"} 32. 5 mm {1-1/4"} Cable access hole ø18 mm {11/16"} Sideway cable exit 1. Locally procure four camera-mounting screws suitable for the installation surface and structure of the wall/ceiling or junction box. [. . . ] The maximum extensible length is shown in the table. Type of coaxial cable Recommended (m) maximum cable length (ft) RG-59/U RG-6/U RG-11/U RG-15/U (3C-2V) (5C-2V) (7C-2V) (10C-2V) G Cable Length and Wire Gauge 24 V AC The recommended cable length and thickness are shown in the table for reference. The voltage supplied to the power terminals of the camera should be within 19. 5 V AC and 28 V AC. Recommended wire gauge for 24 V AC line. 250 825 500 1 650 600 1 980 800 2 640 Copper wire size (AWG) Length of (m) Cable (Approx. ) (ft) #24 (0. 22 mm2) 95 314 #22 (0. 33 mm2) 150 495 #20 (0. 52 mm2) 255 842 #18 (0. 83 mm2) 425 1 403 Scanning system: Scanning: Horizontal: Vertical: Horizontal resolution: Video output: Automatic Gain Control (AGC): Automatic Tracing White Balance (ATW): Signal-to-noise ratio: Minimum illumination: Back Light Compensation (BLC): Detail: Lens: Focal length: F number: Panning range: Tilting range: Azimuth range: Ambient operating temperature: Ambient operating humidity: Power source and power consumption: Dimensions: Weights: I Power Connection Connect the power source to the 3-wire pigtail sticking out from the camera, using the procured power cable. 768 (H) x 492 (V) pixels, interline transfer CCD 3. 6 (H) x 2. 7 (V) mm (equivalent to scanning area of 1/4" pick-up tube) Internal, Line-lock (24 V AC only) or multiplexed vertical drive (VD2) 2 : 1 interlace 525 lines / 60 fields / 30 frames 15. 734 kHz 59. 94 Hz 480 TV lines 1. 0 V[P-P] NTSC composite 75 /BNC conector +18 dB ON only 50 dB (equivalent to AGC Off, weight On) 1. 6 lx {0. 16 foot-candle} at F1. 4 (WIDE) On or Off Sharp or Soft, selectable 2x variable focal lens f=2. 8 - 5. 8 mm F1. 4 - 1. 9, close ±100 ° ±75 ° ±100 ° ­10 °C to +50 °C {14 °F to 122 °F} Less than 90 % 12 V DC, 235 mA 24 V AC 60 Hz, 2. 8 W ø135 mm x 90 mm (H) {ø 5-5/16" x 3-9/16" (H)} 0. 46 kg {1. 01 lbs. } G Wire Colors & Functions 12 V DC Use the formula below to calculate the power cable and power supply. The voltage supplied to the power terminals of the camera should be within 10. 5 V DC and 16 V DC. [. . . ]