User manual PANASONIC WV-CL830

[. . . ] Colour CCTV Cameras WV-CL830/WV-CL834 (Lens : option) Before attempting to connect or operate this product, please read these instructions completely. ENGLISH VERSION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or coloured black. [. . . ] The display shown below appears and the CAMERA ID starts blinking. Blinking Notes: · The CAMERA ID stops at the edges of the monitor screen. · The CAMERA ID moves faster if any of / / / is kept pressed for a second or longer. To return to the CAM SET UP menu Move the cursor to RET and press . Light Control Setting (ALC/ELC) You can select the mode for adjusting the lens iris. The modes are as follows: ALC: Select this mode when an auto iris lens (ALC lens) is used with this camera. ELC: Select this mode when a fixed iris lens or manual iris lens is used with this camera. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON SENS UP OFF SYNC INT WHITE BAL ATW MOTION DET OFF LENS DRIVE DC END SET UP ENABLE WV-CL830 2. Move the CAMERA ID to the desired position by pressing / / / . Press to fix the position of the CAMERA ID. The mode returns to the previous CAMERA ID menu. Move the cursor to the ALC/ELC parameter. Under bright lighting conditions such as outdoors, use an ALC type lens because the ELC control range is not wide enough under these conditions. Use an ALC type lens if phenomena below occur: · Strong smear and/or blooming on highlight objects such as spotlight or sunlight from windows. · Noticeable flicker in the picture and/or colour rendition variations. If ELC is selected, SHUTTER is not available. Back Light Compensation (BACK LIGHT COMP) Back light compensation is available in for both the ALC and ELC mode. It eliminates by strong background lighting which makes the camera picture dark, such as a spotlight. You can select one of two modes (PRESET ON or PRESET OFF) of back light compensation. 2-1. ALC Mode with PRESET ON In normal use the important object in a scene is placed in the centre of the monitor's screen. In the factory setup mode, more photometric weight is given to the centre of the screen (where the important object is located) than to the edge of the picture (where a bright back light would most likely be located). In this mode, even though the backlight may vary, the object at the centre of the screen can be still be clearly seen. Note: If ELC is selected, set LEVEL according to this procedure. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON SENS UP OFF SYNC INT WHITE BAL ATW MOTION DET OFF LENS DRIVE DC END SET UP ENABLE 1. Press after selecting ALC, the ALC CONT menu appears. -22- 2-2. [. . . ] Move the cursor to the LENS DRIVE parameter. Select DC if you are using the auto iris lens that requires a DC drive signal. Select VIDEO if you are using the auto iris lens that requires a video drive signal. -35- 10. Special Menu (SPECIAL) This menu lets you adjust and set up the video signal of the camera to meet your requirements. [. . . ]