User manual PANASONIC WV-CL920

[. . . ] Colour CCTV Cameras Operating Instructions WV -C CL R9 24 Model No. WV-CLR920 WV-CLR924 (Lens : option) Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. FRANÇAIS ENGLISH ENGLISH VERSION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. WARNING: This apparatus must be earthed IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or coloured black. [. . . ] The camera ID consists of up to 16 alphanumeric characters. The camera ID display can be switched on or off on the monitor screen. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON (DNR-H) SENS UP OFF SYNC INT WHITE BAL ATW1 MOTION DET OFF LENS DRIVE DC RET Character Cursor 0123456789 ABCDEFGHIJKLM NOPQRSTUVWXYZ (). , '":;&#!?= +-*/%$ÄÜÖÆÑÅ SPACE POSI RET END RESET . . . . . . . . . . . . . . . . Character Area Command Editing Area Pointer CAMERA ID menu 3. Move the cursor to the character you want to edit by pressing / / / . The selected character appears in the editing area. (The pointer in the editing area moves to the right automatically at this moment. ) 5. Repeat the steps above until all characters are edited. To enter a blank space in the CAMERA ID Move the cursor to SPACE and press . To replace a specific character in the CAMERA ID 1. Move the cursor to the editing area by pressing . Move the cursor to the CAMERA ID parameter. The cursor on the letter "0" is highlighted. 2. Move the pointer to the character to be replaced by pressing or . Then move the cursor to the character area and select a new character. To erase all characters in the editing area Move the cursor to RESET and press . All characters in the editing area disappear. To determine the display position of the CAMERA ID 1. The display shown below appears and the CAMERA ID is highlighted. Highlighted 3. Press to fix the position of the CAMERA ID. The mode returns to the previous CAMERA ID menu. Notes: · The CAMERA ID stops at the edges of the monitor screen. · The CAMERA ID moves faster if any of / / / is kept pressed for a second or more. 2. Light Control Setting (ALC/ELC) You can select the mode for adjusting the lens iris. [. . . ] Default: OFF ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON (DNR-H) SENS UP OFF SYNC INT WHITE BAL ATW1 MOTION DET OFF LENS DRIVE DC ** SPECIAL ** UP SIDE DOWN CHROMA GAIN AP GAIN PEDESTAL BW BURST (BW) CAMERA RESET RET END OFF . . . . I. . . . Camera Picture Upside Down Positioning (UP SIDE DOWN) 1. Move the cursor to the UP SIDE DOWN parameter. Select ON when you want to turn the picture upside down. or AUTO1: The camera selects black and white mode if the picture is dark, or colour mode if the picture is bright enough. -41- Note: Colour picture switches to black-andwhite picture and vice versa in approximately 1 or 2 minutes after recognition of illuminance. [. . . ]