User manual PANASONIC WV-CP110

[. . . ] Serial No. WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. FEATURES · Auto Light Control (ALC)/Electronic Light Control (ELC) · Automatic Gain Control (AGC) +15 dB and Automatic Tracing White Balance (ATW) · Minimum illumination of 0. 6 lx (0. 06 footcandle) at F0. 75 [equivalent to 2. 0 lx (0. 2 footcandle) at F1. 4] · · · · Signal-to-noise ratio of 50 dB Horizontal resolution of 480 lines Built-in microphone Easy connection with specified monitor by a coaxial cable PRECAUTIONS 1. Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or covers. [. . . ] y Lens (option) u Camera Mounting Adapter There is a hole for mounting the camera onto a mounting bracket. The camera is originally designed to be mounted from the bottom, but a top-mounting type is also available. To mount from the top, remove the mount adapter from the bottom of the camera by removing two fixing screws. Attach the mount adapter to the top as shown in the diagram, then mount the camera on the mounting bracket. Make sure that two original screws are used when mounting the mount adapter; longer type screws may damage inner components. i Video Output Jack (VIDEO OUT) Connect this jack (2. 5 mm mini jack) with the control monitor to adjust or confirm settings such as the pan angle or focus. Rear Cover !1 Automatic Light Control/Electronic Light Control Selector (ALC, ELC) Select the mode according to the lens type that is used with this camera. ALC: Select this mode when an auto iris lens (ALC lens) is used with this camera. ELC: Select this mode when a fixed iris lens or manual iris lens is used with this camera. !2 Detail/Aperture Level Selector (SOFT, SHARP) The detail/aperture level can be selected with this selector. Set it to the desired position while observing the picture on the monitor. SOFT: Select this position when a Quad System is connected to this camera. !3 Back Light Compensation Mode Selector (BLC ON, OFF) Select the mode according to the position of the object and light conditions. ON: Select this mode when a strong light such as a spotlight is in the background. !4 Microphone ON/OFF Selector (MIC ON, OFF) Select on or off according to need. !5 Power Indicator (POWER) Lights when power is supplied. VIDEO OUT VIDEO IN ON OFF POWER VIDEO OUT Control Monitor !65 Microphone Volume Control (VOLUME) Adjust to prevent howling. This control is preset in the Centre position at the factory. o Coaxial Cable Connector Connect a coaxial cable (to be procured locally) between this connector and the CAMERA IN connector of the specific monitor (or Camera Drive Unit). [. . . ] Fix the camera mounting bracket on the wall or ceiling to be installed by two screws (to be procured locally). Insert the camera fixing screw on the pan head into the camera mounting adapter, and tighten the pan head firmly. Connect the camera and the monitor with the coaxial cable (to be procured locally). Note: Coaxial cable can be passed through the centre hole of the camera mounting bracket. Camera Mounting Bracket Camera Mounting Bracket Fixing Screws Coaxial Cable DIMENSIONS OF MOUNTING BRACKET Unit: mm (inch) 90° 83. 5 (3-5/16) 15 (9/16) 85 (3-3/8) 40 (1-9/16) 5. 5 (7/32) 120 (4-3/4) 164 (6-7/16) Cautions on installation Use wood screws with the camera mounting bracket that are suitable for Installation into a wood base of appropriate dimensions and strength. [. . . ]