User manual PANASONIC WV-CP220

[. . . ] If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a qualified electrician. WARNING: This apparatus must be earthed. The serial number of this product may be found on the top of the unit. You should note the serial number of this unit in the space provided and retain this book as a permanent record of your purchase to aid identification in the event of theft. [. . . ] To prevent electric shock, do not remove screws or cover. There are no user-serviceable parts inside. Refer servicing to qualified service personnel. The camera could be damaged by improper handling or storage. · Do not expose the camera to rain or moisture, or try to operate it in wet areas. Do take immediate action if ever the camera do becomes wet. Turn power off and refer servicing to qualified service personnel. Moisture can damage the camera and also create the danger of electric shock. · Never face the camera toward the sun. Whether the camera is in use or not, never face it toward the sun. Do use caution when operating the camera in the vicinity of spot lights or other bright lights and light reflecting objects. · Do not operate the camera beyond its temperature, humidity or power source ratings. Do not use the camera in an extreme environment where high temperature or high humidity exist. Use the camera under conditions where temperatures are within -10°C - +50°C, and humidity is below 90%. The input power source is 220 - 240V AC 50 Hz for WV-CP220, 12V DC for WV-CP222 or 24V AC 50 Hz for WV-CP224. -4- MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS (7) (8) (6) (9) (10) (1) (4) (2) (3) (11) @ ! (5) (5) (5) WV-CP220 WV-CP222 -5- WV-CP224 (1) Auto Iris Lens Connector This 4-pin connector supplies the power and DC control signal to the auto iris lens. (2) Flange-back Adjusting Ring This ring is used to adjust the back focal length or picture focus by rotating this ring. (3) Lens (Option) See page 11, 12, 13, 14 and 15 for details on lens selection. Standard C-mount lens can be used with the camera by use of optional lens mount converter (C-mount adaptor) WV-AD20. (4) Camera Mounting Screw Hole This threaded hole (1/4" - 20) is used to mount the camera onto a mounting bracket or tripod. (5) Video Output Connector (VIDEO OUT) A 1. 0 V[p-p] / 75 composite video signal is provided at this connector. Whenever the multiplexed vertical drive (VD2) signal is supplied to this connector, the camera synchronization mode is automatically set to Vertical Drive Lock. (6) AC Power Cord (7) Sync Selection Switch (LL/INT) (WV-CP220/WV-CP224) This switch is used to select the camera synchronization mode. INT: The camera synchronization mode is set to internal 2 : 1 interlace. [. . . ] Turn the flange-back adjusting ring to the desired position. Caution: Do not turn this ring too much to counterclockwise as this could damage the inner glass and CCD image sensor. Tighten the screws on the flange-back adjusting ring. Note: Do not apply the extreme torque (0. 5 kg. cm is recommended) to the screw on the Flangeback Adjusting Ring. LENS MAINTENANCE AND CLEANING 1. [. . . ]