User manual PANASONIC WV-CP232

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the top of the unit. You should note the serial number of this unit in the space provided and retain this instruction as a permanent record of your purchase to aid identification in the event of theft. Serial No. WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. FEATURES · Unobtrusive smoke detector housing design · Horizontal resolution of 330 lines for WV-CP232 or 380 lines for WV-BF320 · Minimum illumination of 10 lx (1. 0 foot-candle) for WV-CP232 or 0. 5 lx (0. 05 foot-candle) for WV-BF320 · Signal-to-noise ratio of 46 dB with AGC off · Exclusive lens is provided PRECAUTIONS 1. [. . . ] Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or covers. There are no user serviceable parts inside. Ask a qualified service person for servicing. The camera could be damaged by improper handling or storage. Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately and ask a qualified service person for servicing. Moisture can damage the camera and also create the danger of electric shock. Do not use strong or abrasive detergents when cleaning the camera body. Pass the cables through the cable hole. 4. Connect the cables as shown in the diagram. 5. Mount the camera onto the ceiling by fixing it with the mounting screws. Note: The arrow mark on the camera's base plate indicates the direction of the camera and coincides with the top of the image displayed on the monitor. To monitor images in upright position, confirm that the arrow mark points in the right direction before fixing the camera with the screws. 6. Attach the panel cover to match the "Panasonic" logo and arrow mark, and rotate the cover clockwise. Make sure the panel cover is closed firmly. Arrow mark s CHANGING OF CAMERA INSTALLATION POSITION This camera can pick up images through the holes on both sides of the panel cover. This requires moving the position of the camera. To pick up images through the hole above, follow the procedure shown below. [. . . ] To pick up images through the hole above, follow the procedure shown below. Detach the panel cover by rotating it counterclockwise. Remove the two screws holding the camera shown in the diagram. 3. Tilt the camera in the direction of the Arrow Mark until the protrusions on the camera fit into the grooves in the upper portion of the screw hole. [. . . ]