User manual PANASONIC WV-CP450

[. . . ] Colour CCTV Cameras WV-CP450/WV-CP454 (Lens : option) Before attempting to connect or operate this product, please read these instructions completely. ENGLISH VERSION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or coloured black. [. . . ] Move the cursor to the character you want to change by pressing / / / . The selected character appears in the editing area. (The pointer in the editing area moves to the right automatically at this moment. ) 5. Repeat the steps above until all characters are edited. To enter a blank space in the CAMERA ID Move the cursor to SPACE and press . To edit a specific character in the CAMERA ID 1. Move the cursor to the editing area by pressing . Move the cursor to the CAMERA ID parameter. The cursor on the letter "0" starts blinking. 2. Move the pointer to the character to be edited by pressing or . Then move the cursor to the character area and select a new character. To erase all characters in the editing area Move the cursor to RESET and press . All characters in the editing area disappear. To determine the display position of the CAMERA ID 1. The display shown below appears and the CAMERA ID starts blinking. Blinking Notes: · The CAMERA ID stops at the edges of the monitor screen. · The CAMERA ID moves faster if any of / / / is kept pressed for a second or longer. To return to the CAM SET UP menu Move the cursor to RET and press . Light Control Setting (ALC/ELC) You can select the light control mode according to the lens type. ALC: If you use the auto iris lens, select this parameter. ELC: If you use a fixed or manual iris lens, select this parameter. 2. Move the CAMERA ID to the desired position by pressing / / / . Press to fix the position of the CAMERA ID. [. . . ] Lens Drive Signal Selection (LENS DRIVE) This item is used to select the type of auto iris lens drive signal to be supplied to the lens from the auto iris lens connector. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER --AGC ON SYNC INT WHITE BAL ATW LENS DRIVE DC END SET UP ENABLE 1. Move the cursor to the LENS DRIVE parameter. Select DC if you are using the auto iris lens that requires a DC drive signal. Select VIDEO if you are using the auto iris lens that requires a video drive signal. -31- 8. [. . . ]