User manual PANASONIC WV-CP480

[. . . ] Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or covers. There are no user-serviceable parts inside. Ask qualified service personnel for servicing. [. . . ] · Prepare a dual-trace oscilloscope and supply it with the video output of the camera to be adjusted and that of the reference camera. · Set the oscilloscope to the vertical rate and expand the V-sync portion. **SYNC** · Select a proper COARSE phase from 16 V PHASE steps (22. 5 degrees/step) that makes the COARSE 1(1--16) two video signals on the oscilloscope the closest. + · Select a proper FINE phase so that the two video signals on the oscilloscope come as close as possible. RET TOP END Notes: · Moving the "I" cursor across the +/- end will shift the FINE range. · Press L and R simultaneously to reset the V PHASE to the default (0 degree). · Keep pressing L or R for a second to move the "I" cursor faster if necessary. · Spike noise if contained in the AC mains may disturb synchronization of LL. VBS Phase Adjustment (H PHASE/ SC) · Select INT for SYNC and press SET. · Supply a VBS (Composite color video or black-burst) signal to the GEN-LOCK IN terminal. **SYNC** · Select EXT (VBS) and press SET. H PHASE . . . . . . . . I A sub menu displaying H PHASE and SC + (Sub carrier) opens. SC COARSE 1(1--4) <H PHASE Adjustment> + · Prepare a dual-trace oscilloscope and supply it the video output of the camera RET TOP END to be adjusted and the VBS. · Set the oscilloscope to the horizontal rate and expand the H-sync portion. · Move the "I" cursor so that phase of the VBS and that of the camera match on the oscilloscope. Adjustable range: From zero to ­ 2. 0 microseconds <SC (Sub-carrier) Phase Adjustment> · Connect the camera to a special effect generator (SEG) and supply the output of the SEG to a monitor. · Select a proper COARSE phase from 4 steps (90 degrees/step) while observing the original scene and the scene on the monitor to make these colors similar. · Select a proper FINE phase so that these colors match as closely as possible. · For more accurate adjustment, prepare a vectorscope and supply it with the camera signal to be adjusted and the output of the SEG as a reference signal. VS Phase Adjustment (H PHASE) · Supply a VS (Composite monochrome video or composite HV) signal to the GEN-LOCK IN terminal. · Adjust the H phase referring to <H PHASE Adjustment> described above. **SYNC** H PHASE . . . . . . . . I + SC FINE . I. . . . . . . 8. Motion Detection Setting (MOTION DET) When a series of changes in pictures is detected, the camera outputs an alarm to the external device such as a disk recorder. [. . . ] · While the SENS UP function is selected, noise, spots or a whitish phenomenon may appear in the picture when the sensitivity of the camera is increased. · Only when OFF, X2 FIX, or X2 AUTO is selected for sensitivity enhancement (SENS UP), It is possible to perform ABF adjustment or to select AUTO for C/L B/W on the BACK-FOCUS SETUP menu. When a sensitivity rate other than X2 FIX or X2 AUTO is selected, use PRESET and FIX for C/L B/W on the BACK-FOCUS SETUP menu. 17-6. Communication (COMMUNICATION) Select a communication mode depending on whether the camera is connected with a Receiver (WV-RC100, WV-RC150). [. . . ]