User manual PANASONIC WV-CS1S

[. . . ] The fact that the equipment operates satisfactorily does not imply that the power point is earthed and that the installation is completely safe. For your safety, if in any doubt about the effective earthing of the power point, consult a qualified electrician. For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. [. . . ] Select OFF if you are not using the home position function. Setup menu *** SET UP MENU *** PRESET 1* MAP* HOME POSITION SELF RETURN AUTO MODE LOCAL/REMOTE CAMERA * 15 10MIN OFF LOCAL - 16 - s Self Return Setting · To set a time-out parameter for return to the home position Move the cursor to SELF RETURN and select a return time by moving the joystick to the left or right. Return time changes as follows: 1MIN 2MIN 60MIN MIN signifies minute(s). 3MIN 30MIN 5MIN 10MIN Setup menu *** SET UP MENU *** PRESET 1* MAP* HOME POSITION SELF RETURN AUTO MODE LOCAL/REMOTE CAMERA * 15 10MIN OFF LOCAL 20MIN Setup menu s Auto Mode Setting 1. To set auto mode Move the cursor to AUTO MODE and select a mode by moving the joystick to the left or right. Modes change as follows: OFF SEQ SORT AUTO PAN *** SET UP MENU *** PRESET 1* MAP* HOME POSITION SELF RETURN AUTO MODE LOCAL/REMOTE CAMERA * 15 10MIN AUTO PAN* LOCAL AUTO PAN setting menu 2. When AUTO PAN is selected, set details as follows: Move the cursor to AUTO PAN* and press the CAM (SET) key to display the AUTO PAN setting menu. ** AUTO PAN ** POSITION SET SPEED ENDLESS DWELL TIME RET START END . . . I. . . . To set a panning start position and panning end position Follow the steps below. (1) Move the cursor to POSITION SET and press the CAM (SET) key. (2) Move the joystick to the left or right to select a panning start position and press the CAM (SET) key. This determines the start position and the cursor moves to END. (3) Move the joystick to the left or right to select a panning end position and press the CAM (SET) key. Move the character cursor to the character you want to change by using the joystick, and press the CAM (SET) key. The selected character appears in the editing area. (The blinking editing cursor moves to the right automatically at this moment. ) 3. Repeat the steps above until all characters are edited. · After editing the camera identification characters, follow the steps below to set the position of the CAMERA ID on the monitor screen. Move the cursor to POSI, and press the CAM (SET) key to display the ID position menu. The CAMERA ID starts blinking and the ID position menu appears in the display. Use the joystick to decide the position of the CAMERA ID on the monitor screen. Press the MON (ESC) key to fix the position, and return to the character editing menu. When you want the editing cursor to move to a specific character in the editing area, move the character cursor to "" or "", and press the CAM (SET) key. This function helps you to edit or correct a specific character. [. . . ] Use MOLEX band tool part number 57027-5000 (for UL-Style Cable UL1015) or 57026-5000 (for ULStyle UL-1007) for clamping the contacts. After clamping the contacts, push them into the proper holes in the accessory connector of this camera until they snap in place. Up Up Wire Wire 4 2 3 1 Contact Contact How to assemble the cable with the accessory connector Strip back the cable jacket approx. 3 mm (0. 1 inch) and separate the individual conductors. Approx. 3 mm (0. 1 inch) 0. 1 inch Wire Wire Up A Contact Contact Insert Insert the wire until A position Insert the wire until A position and clamp the contacts. [. . . ]