User manual PANASONIC WV-CS554

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. WARNING: This apparatus must be earthed. IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. [. . . ] It eliminates interference by strong background lighting which makes the camera picture dark, such as a spotlight. Move the cursor to SUPER-D2 and select ON. ** ALC CONT ** BACK LIGHT COMP SUPER-D2 ON LEVEL RET END . . . I. . . . . If you want to adjust the video output level, move the "I" cursor for LEVEL. Adjust to the desired level by pressing L or M. (To be continued reverse page) SETTING PROCEDURES 2-2. ALC Mode with SUPER-D2 OFF and ELC Mode Note: If ELC is selected, set MASK SET according to this procedure. Move the cursor to SUPER-D2 and select OFF. (When you select ELC, SUPER-D2 is not available. ) The MASK SET appears on the menu. ** ALC CONT ** BACK LIGHT COMP SUPER-D2 MASK SET LEVEL . . . I. . . . . Move the cursor to MASK SET and press I. The 48 mask areas appear on the monitor screen. The cursor is blinking in the upper left corner of the screen. RET Blinking 3. Move the cursor to the area where backlight is bright and press I to mask that area. Move the cursor to SENS UP and select the parameter for electronic sensitivity enhancement. The preset values for SENS UP (electronic sensitivity enhancement) change by pressing L or M as shown right: OFF X32 FIX X2 AUTO X16 FIX X4 AUTO X10 FIX X6 AUTO X6 FIX X10 AUTO X4 FIX X2 FIX OFF Notes: · When ON is selected for SUPER-D2 in the ALC CONT menu, FIX is not available for this item. · When you select AUTO for SENS UP and ON for SUPER-D2, the SENS UP function has priority so that the SUPER-D2 function is not activated automatically. · While the SENS UP function is selected, noise, spots or a whitish phenomenon may appear in the picture when the sensitivity of the camera is increased. Synchronization Setting (SYNC) You can select internal sync (INT) mode or line-lock (LL) mode. Additionally, this model accepts the VBS signal (composite colour video or blackburst signal) and VS signal (B/W composite video or composite sync signal). The VD2 signal (multiplexed vertical drive signal) with the composite video output signal from external equipment such as a matrix switcher is also acceptable. Whenever the VD2 signal is supplied to this camera, the camera automatically switches to the VD2 sync mode. Move the cursor to SYNC and select LL or INT. If LL is selected, the SYNC menu appears. (If INT is selected, the synchronization mode is automatically set to internal sync pulse, and the menu is not displayed. ) Important Notices: 1. [. . . ] The SPECIAL menu WHITE BAL ATW1 BW OFF MOTION DET OFF appears on the monitor screen. LENS DRIVE END DC SET UP ENABLE 10-1. Camera Picture Upside Down Positioning (UP SIDE DOWN) 1. Select ON when you want to turn the picture upside down. 10-2. While observing the vectorscope or colour video monitor, move the "I" cursor to adjust the chroma level. 10-3. [. . . ]