User manual PANASONIC WV-CU550

[. . . ] If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. H G The lighthing flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] When used in a system with either Receivers (WV-RC100, WV-RC150 or WV-RC170) or with Combination cameras (WV-BS200, WV-CS300, WV-CS500 or WV-CS600), the WV-CU550A can control camera functions such as zoom and focus and can also control accessory equipment such as Pan/Tilt Heads. In addition, the WV-CU550A can control sequential switching in systems programmed by the Set Up Menu of the WJ-SX550A Matrix Switcher. PRECAUTIONS · All necessary procedures, with regards to the installation of this unit should be made by qualified service personnel or system installers. · Do not attempt to disassemble the unit. In order to prevent electric shock, do not remove screws or covers. There are no user-serviceable parts inside. Do refer all servicing to qualified service personnel. It could be damaged by improper handling or storage. · Do not expose the unit to rain or moisture, or try to operate it in wet areas. Do take immediate action if the unit becomes wet. Turn the power off and refer servicing to qualified service personal. Moisture can damage the unit and also create the danger of electric shock. · Do not use strong or abrasive detergents when cleaning the unit body. Do use a dry cloth to clean the unit when dirty. In case the dirt is hard to remove, use a mild detergent and wipe gently. · Do not operate the unit beyond its temperature, humidity or power source ratings. Do not use the unit in an extreme environment where high temperature or high humidity exist. Use the unit under conditions where temperatures are within -10°C - +50°C (14°F - 122°F), and humidity is below 90%. The input power source is 220 - 240V AC 50 Hz. FEATURES The WV-CU550A System Controller, when combined with the WJ-SX550A Matrix Switcher and WJ-AD550 Extension Unit enables control of the following functions: · Routing of up to 128 cameras to any one of 16 monitors. · Remote control of up to 128 cameras and auxiliary equipment, by using optional receivers and accessories, including: 1. Remote control of Pan-Tilt Head and Camera Housing. Remote control of Motorized Zoom Lenses:Focus, Zoom and Iris. Remote control of camera settings, including Electronic Sensitivity Up, Electronic Shutter, Electronic Zoom, and more. [. . . ] After alarm acknowledgement, press the Alternate (ALT) Switch then press this switch to reset the all activated alarms at once. 22. Data Input/Output Connectors (DATA IN, OUT) These connectors are used to transmit/receive control data to/from the WJ-SX550A Matrix Switcher in a system. 23. Termination Switch (TERM ON/OFF) This switch is used to enable termination of this controller's data connector. 24. Controller Unit Number Switch (CONTROLLER UNIT NO. ) This switch is used to identify the unit number of the System Controller in multiple system controller applications. [. . . ]