User manual PANASONIC WV-CW474AF

[. . . ] (1) Auto Light Control (ALC) (2) The SUPER-D2 function eliminates interference by strong background lighting which makes the camera picture dark, such as a spotlight. Dynamic range of 46 dB (Typ) (3) Internal, Line-Locked, Multiplexed Vertical Drive (VD2) Sync (4) Auto/Manual White Balance Function (5) Electronic Shutter Function 2. Signal-to-noise ratio of 50 dB (Equivalent to AGC Off) 3. Minimum illumination of 2. 0 lx (0. 20 footcandle) (WIDE) (Color mode) Minimum illumination of 0. 2 lx (0. 02 footcandle) (WIDE) (Black-and-white mode) Minimum illumination of 0. 8 lx (0. 08 footcandle) (WIDE) with the WV-CW2C optional dome cover (Color mode) Minimum illumination of 0. 1 lx (0. 01 footcandle) (WIDE) with the WV-CW2C optional dome cover (Black-and-white ) 4. [. . . ] OFF: The electronic zoom function is disabled. While the cursor is on EL-ZOOM, press I(S). ** EL-ZOOM ** The EL-ZOOM setting menu appears. Move the cursor to PUSH SET for ZOOM and ZOOM PUSH SET press I(S) to display the ZOOM setting U TILT D/L PAN R menu. Press I(U) or I(D) to zoom in or out the image. Move the cursor to PUSH SET for PAN/TILT and press I(S). Press I(U) or I(D) I(L) or I(R) to ** EL-ZOOM ** change the angular field of view. To return to the EL-ZOOM setting menu, press ZOOM PUSH SET I(S). U ZOOM D 000 000 RET 6. Move the cursor to the area where backlight is bright and press I(S) to mask that area. (When the cursor is moved on an area that has already been masked, the mask and cursor start blinking. ) Blinking You can select internal sync (INT) mode, line-lock (LL) mode or the VD2 signal (multiplexed vertical drive signal) mode. The priority for the sync modes is as follows: (1) Multiplexed Vertical Drive (VD2) (Highest priority) (2) Line-lock (LL) (3) Internal Sync (INT) (Lowest priority) 2. The line-lock mode has a submenu for line-lock vertical phase adjustment. If the camera installation is relocated, check the vertical phase adjustment again since the AC line phase may be different. 8. Motion Detector Setting (MOTION DET) The motion detector detects the moving objects in the scene by monitoring changes in brightness level. You can select the level of sensitivity for motion detection. When this camera is connected to a compatible intelligent CCTV system, the camera transmits an alarm signal by multiplexing it with the video signal. Move the cursor to MOTION DET and select ON. The MOTION DETECT menu appears on the monitor screen. ** MOTION DETECT ** LEVEL DISPLAY MODE ALARM MASK SET RET END . . . . . . . . I + OFF 2. The blemish compensation position setting screen appears. Press I(L), I(R), I(U) or I(D) to place the "+" cursor on the blemish position. After moving the "+" cursor to a position where the blemish looks inconspicuous, press I(S). Consequently, the blemish compensation position is set up and the PIX OFF menu is restored. [. . . ] The PUSH SW is highlighted to indicate that the white balance is being set. When the white balance setting is completed, the PUSH SW returns to normal display. Note: If white balance is not set, the PUSH SW is being highlighted. X2 AUTO: Sensitivity will be automatically doubled at the maximum in the black and white mode. Notes: · "X2 AUTO" is not available when AGC is set to OFF. [. . . ]