User manual PANASONIC WV-LA608

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the rear of the unit. You should note the serial number of this unit in the space provided and retain this instruction as a permanent record of your purchase to aid identification in the event of theft. [. . . ] Serial No. WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. FEATURES · Unobtrusive Passive Infrared Sensor housing design · Signal-to-noise ratio of 46 dB with AGC off · Exclusive lens is provided · Horizontal resolution of 330 lines for WV-LA608 or 380 lines for WV-BF300 · Minimum illumination of 42 lx (4. 2 foot-candle) for WV-LA608 or 2. 1 lx (0. 21 foot-candle) for WV-BF300 PRECAUTIONS 1. Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or covers. There are no user serviceable parts inside. Ask a qualified service person for servicing. The camera could be damaged by improper handling or storage. Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately and ask a qualified service person for servicing. Moisture can damage the camera and also create the danger of electric shock. Detach the panel cover by pressing it at the top and bottom as shown in the diagram. 50mm (2") To AC Adapter To Video Input 3. Connect the cables as shown in the diagram. 5. Mount the camera onto the wall by fixing it with the mounting screws. Note: To monitor images in upright position, confirm that the cable outlet is up as shown in the diagram before fixing the camera with the screws. 6. Make sure that the cover is closed firmly and that the camera wires are not caught. INSTALLATION OF OPTIONAL LENS To install the optional lens, follow the procedure shown below. Detach the cover by pressing it at the top and bottom as shown in the diagram. 2. Detach the camera by removing the four screws shown in the diagram. 3. Place the brackets (provided as standard accessory) on both sides of the camera and tighten with the two screws. 4. Install the camera with the brackets on the base with two screws. [. . . ] Place the brackets (provided as standard accessory) on both sides of the camera and tighten with the two screws. 4. Install the camera with the brackets on the base with two screws. Caution: Confirm that the camera is mounted with the top up. Top Side view of the camera 5. Remove the lens (originally mounted on the camera) from the camera by turning it counterclockwise. [. . . ]