User manual PANASONIC WV-LA9C3B

[. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1965 The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. SA 1966 The serial number of this product may be found on the bottom of the unit. [. . . ] The lens focus will be adjusted automatically for the object displayed when you pressed the button. Note: As the factory default, auto focus has been assigned to the B button and top button. You can assign auto focus to the function buttons (F1 to F4/F5 to F8) or joystick function buttons (A, B, and top buttons). 52 and 53 for assignment. ) Note: Available zooming rates differ depending on the motorized zoom lens. 40 Preset Position Control Preset position is the function to register camera monitoring positions (preset positions) associated with position numbers. By entering the position numbers, you can move cameras to the preset positions. Note: To activate this function, you need to register the preset positions of combination camera. Select a system unit, monitor, and desired camera. Enter a preset position number by pressing the numeric buttons. The entered number will appear on the LCD. Home Position Control Home position is the default preset position. You can move the camera to the home position only by pressing the PRESET/PGM PRESET button. Note: To activate this function, you need to register the home position of combination camera. To return to the camera image more recently selected, press the + button while holding down the HISTORY button. The camera image more recently selected will be displayed on the monitor. (Camera 1 3 128) Mon01 Cam001 ___11 F1 F2 F3 F4 3. The registered camera and preset position will be selected, and the camera position image will be displayed on the active monitor. Mon02 Cam001 HD316 F1 F2 F3 F4 Mon01 C-P011 HD316 F1 F2 F3 F4 Mon02 Cam003 HD316 F1 F2 F3 F4 Camera Selection Recall Every time you select a camera or camera position, this system controller memorizes up to 10 steps of camera selection. You can recall these operations in order or reverse order. In the following procedure, you can track back the camera images formerly displayed. Note: After power-off or system unit selection, the memorized camera operations will be cleared. In the following example, Camera 1 3 128 has been selected. Press the ­ button while holding down the HISTORY button. The camera image formerly selected will be displayed on an active monitor. (Camera 128 3) Note: To recall camera images more formerly selected one by one, repeat pressing the ­ button while holding down the HISTORY button. [. . . ] Function assignment settings of the F1 to F8 buttons may be wrong. 18. You cannot activate any functions even when pressing the function buttons (F1 to F4/F5 to F8). Refer to pp. 52 to 54. Users who have logged into the system may not be authorized to control cameras with these buttons. Check the user level settings of these users. Refer to pp. [. . . ]