User manual PANASONIC WV-LM6B2

[. . . ] 50 % of transmittance) Ceiling board such as plaster board Safety wire (WV-Q105 supplied) Ceiling mount bracket Inner shell Precautions · Refer installation work to the dealer. Installation work requires technique and experiences. Failure to observe this may cause fire, electric shock, injury, or damage to the product. [. . . ] Failure to observe this may cause a fall of an inappropriate camera resulting in injury or accidents. Mount WV-NS202 on this bracket exclusively. · Avoid installing this bracket in the locations where salt damage occurs or corrosive gas is produced. Otherwise, the mounting portions will deteriorate and accidents such as a fall of the camera may occur. · The screws and fixation mechanisms shall be tightened securely. Failure to observe this may cause a fall of the camera resulting in injury. · Select an installation area that can support the total weight. If a selected area is too weak to support the total weight, a fall of the product may occur resulting in injury. Installation work shall be started after sufficient reinforcement. After tightening the screws or bolts, perform visual check to ensure tightening is enough and there is no backlash. · The protection sheet attached to the dome cover shall be peeled off after installation. Dome cover Installations Be sure to read "Precautions" before installation. The Installation Guide of the network camera, WVNS202, shall be read as well. Slide the covers located on the both lateral sides of the camera and put the inner shell on the camera until the hooks inside the inner shell are held in the holes of the camera (until a click is heard). Important: Put the inner shell down on the camera until the outside cover of the camera cannot be seen from the opening (from which the camera lens is visible) of the inner shell. If this integration is not successfully performed, the inner shell may be removed or the hidden part at the top of the screen may become larger in the WIDE mode. Inner shells Cover Hook Put on until a click is heard How to remove the inner shell Press the inner shell from the front and rear sides inward (at the same vertical position as the hooks) to bend the shell and remove the shell from the camera. Press from the front and rear sides inward to bend (To be continued reverse page) Installations (continued) 2. The camera shall be mounted on the camera mounting bracket (supplied with the camera) after mounting this bracket on a ceiling. For further information, refer to the operating instructions of WV-NS202. Specifications Ambient temperature: Dimensions: Weight: Finish: ­10 °C to +50 °C {14°F - 122°F} 185 mm {7-5/16"} in diameter x 163 mm {6-7/16"} in height Approx. 230 g Main body: ABS resin with silver metallic coating Dome cover: Acrylic resin 3. [. . . ] 230 g Main body: ABS resin with silver metallic coating Dome cover: Acrylic resin 3. q Connect the safety wire locked on this bracket to the safety wire hook. Make sure that the apical ring of the safety wire is engaged with the safety wire hook of the camera by pulling the safety wire after connection. Safety wire hook LOCK OPEN Standard Accessories Operating Instructions (this book) . . . . . . . . . . . . . . . . . . . . . . . [. . . ]