User manual PANASONIC WV-LZ1412A

[. . . ] Extension cords used with the equipment must be three-core and be correctly wired to provide connection to earth. Wrongly wired extension cords are a major cause of fatalities. The fact that the equipment operates satisfactorily does not imply that the power point is earthed and that the installation is completely safe. For your safety, if in any doubt about the effective earthing of the power point, consult a qualified electrician. For U. K. [. . . ] Use this button to select or adjust the parameters of the selected item. The parameter changes each time this button is pressed. (S) (Set Button): This button is used to set the determined parameter. If the item has its own setting menu (as indicated by ), press this button to display the setting menu. · All Reset Operation All Reset allows you to reset all setup menu items to the factory settings if you are unsure about the correct settings. Proceed as follows: (1) Make sure that the CAM SET UP menu is not displayed (a camera picture is displayed). (2) While pressing both (L) and (R), press (S) for a few seconds. The words ALL RESET momentarily appear on the monitor. At this time all adjustments and parameters are reset to the factory default settings. (U) (Up Button): This button is used to move the cursor upwards. Use this button to select an item or adjust the parameters. (D) (Down Button): This button is used to move the cursor downwards. The display shown below appears and the CAMERA ID starts blinking. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER --AGC ON SYNC INT WHITE BAL ATW Blinking WV-CF254 END SET UP ENABLE To edit the CAMERA ID 1. Move the cursor to the CAMERA ID parameter. The cursor on the letter "0" starts blinking. Character Cursor 0123456789 ABCDEFGHIJKLM NOPQRSTUVWXYZ (). , '":;&#!?= +-*/%$ÄÜÖÆÑÅ SPACE POSI RET END RESET Character Area Command Editing Area 2. Move the CAMERA ID to the desired position by pressing (L)/ (R)/ (U)/ (D). Press (S) to fix the position of the CAMERA ID. The mode returns to the previous CAMERA ID menu. Notes: · The CAMERA ID stops at the edges of the monitor screen. · The CAMERA ID moves faster if any of (L)/ (R)/ (U)/ (D) is kept pressed for a second or longer. To return to the CAM SET UP menu Move the cursor to RET and press CAM SET UP menu appears. Pointer . . . . . . . . . . . . . . . . (S). Move the cursor to the character you want to change by pressing (L)/ (R)/ (U)/ (D). After selecting the character, press (S). [. . . ] Note: When you need to set MASK SET, re-adjust to obtain the optimum amount of red and blue gain. 7. Special Menu (SPECIAL) ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER --AGC ON SYNC INT WHITE BAL AWCPUSH SW END SET UP ENABLE This menu lets you adjust and set up the video signal of the camera to meet your requirements. Move the cursor to END on the bottom line of the CAM SET UP menu and press (L) or (R) simultaneously for 2 seconds or longer. The SPECIAL menu appears on the monitor as shown below. 2. [. . . ]