User manual PANASONIC WV-LZ81

[. . . ] If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. [. . . ] Selectable auto iris control signal for the lens from a video signal or DC control signal -3- PRECAUTIONS 1. Do not attempt to disassemble the camera. To prevent electric shock, do not remove screws or covers. There are no user serviceable parts inside. Ask a qualified service person for servicing. The camera could be damaged by improper handling or storage. Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately and ask a qualified service person for servicing. Moisture can damage the camera and also create the danger of electric shock. Do not use strong or abrasive detergents when cleaning the camera body. Use a dry cloth to clean the camera when dirty. OFF: A natural and low-noise picture is obtained under low light conditions. -6- !0 Automatic Light Control / Electronic Light Control Selector (ALC , ELC) Lets you select the mode according to the lens type that is used with this camera. ALC: Select this mode when an auto iris lens (ALC lens) is used with this camera. ELC: Select this mode when a fixed iris lens or manual iris lens is used with this camera. !1 Back Light Compensation Mode Selector (BLC ON, OFF) Lets you select the mode according to the position of the object and light conditions on the screen. BLC ON: More photometric weight is given to the centre of the screen than to the edge of the screen. Select this mode if the background light is strong such as a spotlight. OFF: Lets you this mode if the main object is not located in the centre of the screen and a source of bright light is located near the centre of the screen. !2 Lens Drive Signal Selector (VIDEO, DC) Lets you select the mode according to the type of auto iris lens drive signal to be supplied to the lens from the auto iris lens connector. VIDEO: Select this mode if you are using the auto iris lens that requires a video drive signal. -7- DC: Select this mode if you are using the auto iris lens that requires a DC drive signal. [. . . ] Note: If the camera is connected to the Quad System, glare may appear at the edge of the camera picture on the monitor. If this bothers you, adjust the lens focus to reduce the glare. Focus adjustment for C-mount lens Back-focal Adjusting Ring Screws 2. Turn the back-focal adjusting ring to the desired position. Caution: When the C-mount lens is mounted, do not rotate the ring counterclockwise by force after it stops. [. . . ]