User manual PANASONIC WV-NP472

[. . . ] Colour CCTV Camera Operating Instructions Model No. WV-NP472E day/ nigh t SDI I (Lens : option) (Lens: Option) Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN We declare under our sole responsibility that the product to which this declaration relates is in conformity with the standards or other normative documents following the provisions of Directive EEC/89/336. Wij verklaren als enige aansprakelijke, dat het product waarop deze verklaring betrekking heeft, voldoet aan de volgende normen of andere normatieve documenten, overeenkomstig de bepalingen van Richtlijn 89/336/EEC. Vi deklarerar härmed värt fulla ansvar för att den produkt till vilken denna deklaration hänvisar är i överensstämmelse med standarddokument, eller andra normativa dokument som framstölls i EEC-direktiv nr. Ilmoitamme yksinomaisella vastuullamme, että tuote, jota tämä ilmoitus koskee, noudattaa seuraavia standardeja tai muita ohjeellisia asiakirjoja, jotka noudattavat direktiivin 89/336/EEC säädöksiä. [. . . ] Press L or M to obtain the optimum amount of red gain. Press L or M to obtain the optimum amount of blue gain. Note: When you need to set MASK SET, re-adjust to obtain the optimum amount of red and blue gain. 7. Motion Detector Setting (MOTION DET) The camera detects moving objects in the scene by monitoring changes in brightness level. You can select the level of sensitivity for motion detection. When this camera is connected to a compatible intelligent CCTV system, the camera transmits an alarm signal by multiplexing it with the video signal. Move the cursor to MOTION DET and select ON. The MOTION DETECT menu appears on the monitor screen. Notes: · When the camera is not used in a Panasonic Intelligent CCTV System, select OFF. Otherwise, video equipment may malfunction because of the alarm signal misinterpretation for a time code signal. · The motion detector may malfunction when the lightening equipment continuously turns on and off, or when ELC mode is selected for ALC/ELC. · Set MASK SET over the areas where swaying leaves, curtains, or other objects are detected. · Adjust the detection level on the menu to prevent misinterpretation under low light conditions with noise. · It takes about 0. 2 seconds for the alarm signal to reach the VTR's alarm terminal after the camera detects a moving object. · The motion detector is not specifically intended to prevent theft or fire. 8. Lens Drive Signal Selection (LENS DRIVE) Select a signal form matching to the lens installed. DC: Is applied to a DC driven type lens. VIDEO: Is applied to a video signal type lens. 9. Date Display (Clock) Setting ** MOTION DETECT ** LEVEL DISPLAY MODE ALARM MASK SET RET END . . . . I. . . . Move the cursor to MASK SET and press I. To set MASK SET, proceed as described in steps 2 to 4 of "ALC mode with SUPER-D2 OFF and ELC mode". Move the cursor to ALARM and select ON or OFF to set the alarm for DISPLAY MODE. Note: When using the WV-RM70, WV-CU550 series, WV-CU161 or WV-CU360 controller with this model, select OFF for ALARM. [. . . ] In the menu, scroll down the screen to its end. 3. Click the Return button to go back to the main page. -41- AUXILIARY OUTPUT CONTROL Auxiliary Output Control You can turn on or off the connected device, for example a lamp that is connected to the AUX OUT terminal of the camera. 1. Open the auxiliary output control window clicking the AUX Output Control button in the main page. Select the polarity to switch on or off the connected device. [. . . ]