User manual PANASONIC WV-PB5548

[. . . ] The wire which is coloured brown must be connected to the terminal in the plug which is marked with the letter L or coloured red. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the top of the unit. You should note the serial number of this unit in the space provided and retain this book as a permanent record of your purchase to aid identification in the event of theft. [. . . ] Select OFF or 100 ms for the delay time. Notes: · This item appears only when a Half Duplex (2line) connection is used. · Setting change is disabled when a Full Duplex (4-line) connection is used. · The selected Full or Half Duplex Setting will become valid after the camera has been powered up again. -24- · Installation of Software for RS-485 Communication 1. Insert the Install Disk 1 to the C drive. When the window that says "Please insert the disk labeled: "Disk 2" into drive C:" appears on the monitor screen, insert the Install Disk 2 and press . When the installation is completed, the window that says "485_GUI Set up was completed successfully". After installation of 485_GUI* Set up is completed, open 485_GUI Set up, and set the RS485 communication parameters. * The GUI stands for Graphical User Interface. SETTING PROCEDURES 1. Camera Identification (CAMERA ID) Setting You can use the camera identification (CAMERA ID) to assign a name to the camera. The modes are as follows: ALC: Select this mode when an auto iris lens (ALC lens) is used with this camera. ELC: Select this mode when a fixed iris lens or manual iris lens is used with this camera. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON (DNR-H) SENS UP OFF SYNC INT WHITE BAL ATW1 MOTION DET OFF LENS DRIVE DC RET WV-CLR920 2. Move the CAMERA ID to the desired position by pressing / / / . -26- 1. Move the cursor to the ALC/ELC parameter. Under bright lighting conditions such as outdoors, use an ALC type lens because the ELC control range is not wide enough under these conditions. Use an ALC type lens if the following phenomena occur: · Strong smear and/or blooming on highlight objects such as spotlight or sunlight from windows. · Noticeable flicker in the picture and/or colour rendition variations. If ELC is selected, SHUTTER is not available. Back Light Compensation (BACK LIGHT COMP) Back light compensation is available for both the ALC and ELC modes. It eliminates strong background lighting which makes the camera picture dark, such as a spotlight. You can select one of two modes (PRESET ON or PRESET OFF) of back light compensation. 2-1. [. . . ] Move the cursor to the AP GAIN parameter. While observing the waveform monitor or colour video monitor, move the "I" cursor to adjust the aperture gain level. Move the cursor to the PEDESTAL parameter. While observing the waveform monitor or colour video monitor, move the "I" cursor to adjust the pedestal level (black level). [. . . ]