User manual PANASONIC WV-PS03

[. . . ] Vi erklærer oss alene ansvarlige for at produktet som denne erklæringen gjelder for, er i overensstemmelse med følgende normer eller andre normgivende dokumenter som følger bestemmelsene i direktiv 89/336/EEC. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the top of the unit. You should note the serial number of this unit in the space provided and retain this book as a permanent record of your purchase to aid identification in the event of theft. [. . . ] Note: If white balance is not set, PUSH SW is being highlighted. When you want to adjust white balance manually, press M to select AWC and press I. The AWC menu appears on the monitor screen. (When ATW is selected, pressing I displays the ATW menu. ) 6. Auto-Tracing White Balance Mode (ATW) You can select one of three modes for white balance adjustment as follows: The factory default setting is ATW1. · ATW1 (Auto-Tracing White Balance 1) Move the cursor to WHITE BAL and select ATW1. In this mode, the colour temperature is monitored continuously and thereby white balance is automatically set. The colour temperature range for the proper white balance is approximately 2 600 6 000 K. Proper white balance may not be obtained under the following conditions: ** R B AWC ** . . . . I. . . . + ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER --AGC ON(DNR-H) SENS UP OFF SYNC INT WHITE BAL ATW1 MOTION DET OFF LENS DRIVE DC CLOCK OFF RET MASK SET RET END -18- Manual Fine Adjustment for AWC (ATW) You can set the white balance items manually. To set MASK SET, proceed as described in steps 2 to 4 of "ALC mode with SUPER-D2 OFF and ELC mode". Move the cursor to DISPLAY MODE and press I to see the current setting. The masks that detect the brightness changes start blinking. To raise detection sensitivity, press I to return to the MOTION DETECT menu. To obtain the optimum detection level, move the "I" cursor to adjust the level. Repeat the procedure above to obtain a satisfactory setting. You can select a display position and a style of the date display. The camera ID will be displayed under the position designated here. In the camera setup menu, move the cursor to CLOCK, and press M or L to select a display position. ON (L-UP): Displays at the left-upper corner. ON (L-LOW): Displays at the left-lower corner. ON (R-UP): Displays at the right-upper corner. ON (R-LOW): Displays at the right-lower corner. [. . . ] Notes: · You may need to click the "Reload" button on the browser when the selected picture does not appear due to a newly arisen event that replaces the picture data. · You may need to re-enter the camera address into the address bar of the browser when the buttons do not work properly. · Re-enter the camera address into the address bar and start again from step 1, when the selected picture does not appear though the event is followed by the icon in the list. 2. Click the Alarm button to open the Alarm Setup menu. [. . . ]