User manual PANASONIC WV-PS154

[. . . ] If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN H G CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] (*) If an applicable camera is connected. · Controls camera setup through the specified outboard device connected. · VD/SYNC IN and OUT connectors provided for synchronizing in parallel connection. PRECAUTIONS · Refer all work related to the installation of this product to qualified service personnel or system installers. · Do not block the ventilation opening or slots on the cover. To prevent the appliance temperature from rising, place the appliance at least 5 cm (2 inches) away from the wall. · Do not drop metallic parts through slots. This could permanently damage the appliance. Turn the power off immediately and refer servicing to qualified service personnel. · Do not attempt to disassemble the appliance. To prevent electric shock, do not remove screws or covers. There are no user-serviceable parts inside. Refer maintenance to qualified service personnel. · Handle the appliance with care. Do not strike or shake, as this may damage the appliance. · Do not expose the appliance to water or moisture, nor try to operate it in wet areas. Do take immediate action if the appliance becomes wet. Turn the power off and refer servicing to qualified service personnel. Moisture can damage the appliance and also cause electric shock. · Do not use strong or abrasive detergents when cleaning the appliance body. Use a dry cloth to clean the appliance when it is dirty. When the dirt is hard to remove, use a mild detergent and wipe gently. · Do not operate the appliance beyond its specified temperature, humidity or power source ratings. [. . . ] Accuracy of vertical signal Vertical frequency: 50 Hz ± 0. 0013 Hz Relation between VD/SYNC IN and VD/SYNC OUT The signals from the VD/SYNC OUT connector differ depending on the connected camera and the signals received at the VD/SYNC IN connector of the camera drive unit. The signals supplied from VD/SYNC OUT are as follows: Signal to VD/SYNC IN Connected Camera WV-BP50E or WV-CP110E Composite signal No signal VD signal Composite signal VD signal Composite signal 10 SPECIFICATIONS Power Source: Power Consumption: Camera Input: Video Output: Audio Output: Camera Power Supply: Maximum Distance to Camera: 220-240 V AC 50 Hz Approx. 55 W 1. 0 V[p-p]/75 , BNC Connector 1. 0 V[p-p]/75 , BNC Connector ­10 dB/600 unbalanced, RCA pin jack Regulated current multiplex method (350 mA) Coaxial DC R/300 m (1000 ft. ) of Maximum Cable Type Inner Conductor Cable Length RG-59/U Less than 30 200 m (660 ft. ) RG-6/U Less than 12 500 m (1650 ft. ) Between camera and camera drive unit: 20 . 4. 0 V[p-p]/75 Negative going or VS 1 V[p-p]/75 , BNC Connector 4. 0 V[p-p]/75 Negative going, BNC Connector ­10°C ­ +50°C (14°F ­ 122°F) Less than 90 % 420 (W) X 44 (H) X 350 (D) mm 16-9/16" (W) x 1-3/4" (H) x 13-3/4" (D) 4. 0 kg (8. 8 lbs. ) Maximum DC Resistance: VD/SYNC Input: VD/SYNC Output: Ambient Operating Temperature: Ambient Operating Humidity: Dimensions: Weight: Weight and dimensions shown are approximate. [. . . ]