User manual PANASONIC WV-Q118

[. . . ] PLACES OF INSTALLATION Wall Mount Bracket Instructions Model Nos. There are various ways of installing the camera as shown below. WV-Q118/WV-Q118E Wall Box Wall box Wood Siding Board Wood Siding Board Strong enough to support the camera weight (approx. [. . . ] Mounting Screw Rotate 15° Remove the Camera Mounting Base by pulling up. 4 Cut the Diecast Case as shown. Note: Be sure to protect the Video and Power Cables with the Protection Cover (provided). Cut here 5 Remove the Decoration Cover in order (1) then (2). The Decoration Cover can be removed by pressing on the points (1) at one place, and (2) at 4 places. 11 Attach the camera to the Camera Mounting Base, turn the camera clockwise, and tighten the Mounting Screw (M3, provided). Rotate 15° Notes: · Tigthen the Camera Fixing Screw with a screwdriver. · In attaching the camera to the Camera Mounting Base, loosen the Camera Fixing Screw (M3), then tighten it back with a screwdriver while keeping it pushed up. · The bracket is not shown in the illustration. Camera Mounting Base Decoration cover (1) Decoration cover (2) Camera Press up 6 Fix the Camera Mounting Base (provided with the camera) to the bracket with the four M4L8 Screws (provided). 12 Place the removed Decoration Cover (1) back on the bracket and camera. Note: Be sure to fix the Camera Mounting Base in the up direction as shown. Note: Push the Decoration Cover up till it fits over the bracket with a click. Decoration cover (1) 7 Run the cable around the outside and secure it with the clamp. Secure the cable with the clamp so it goes along the inside of the top case so it does not get in the way when attaching the case and installing the camera. Clamp 8 Attach the top case to the wall and run the cables. Align it with the position the camera will be installed. SPECIFICATIONS Ambient Operating Temperature: Dimensions: Weight: 10°C - +50°C {14°F ­ 122°F} 165 (W) x 140 (H) × 217. 5 (D) mm {6-1/2" (W) x 5-33/64" (H) × 8-37/64" (D)} 650 g {1. 43 lbs} Weight and dimensions indicated are approximate. Specifications are subject to change without notice. 9 Place the removed Decoration Cover(2) back on the bracket and camera. Note: Push the Decoration Cover up till it fits over the bracket with a click. STANDARD ACCESSORIES Screw (M4-L8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Template . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Ring of the Fall Prevention Wire © 2005 Matsushita Electric Industrial Co. , Ltd. [. . . ]