User manual PANASONIC WV-Q151S

[. . . ] · WV-Q151C: Clear dome cover · WV-Q151S: Smoked dome cover (approx. 50 % of transmittance) Precautions · Refer installation work to the dealer. Installation work requires technique and experiences. Failure to observe this may cause fire, electric shock, injury, or damage to the product. [. . . ] Unless the microphone is used, cut the rubber with a nipper or conduct another treatment. <Installation sample> Roof space Safety wire angle (Accessory) Safety wire (Accessory) Ceiling mount bracket Ceiling board Decorative cover WV-NS202 Dome cover Inner shell 4 Installations Be sure to read "Precautions" on the page xx before installation. The Installation Guide of the network camera, WV-NS202, shall be read as well. q Loosen the fixing screw (unremovable) to be used for cover fall prevention. w Unhook the decorative cover from the hooks (3 positions) of the camera mounting plate and remove the decorative cover by turning it counterclockwise. e Take the inner shell out. Fixing screw to be used for cover fall prevention Hook LO CK 2. Remove the screws (M4, 3 positions) and remove the camera mounting plate by turning it counterclockwise. Disengage the portion (a) from the hole (b) (2 positions). Screw (M4) (a) Camera mounting plate FRON T LO CK FRON FRONT T FRONT (b) 5 3. Put Template A (accessory) against the ceiling and make a hole. q Make 4 holes of 12 mm {1/2"} in diameter. w Remove the center part from the template. e Make a hole of 160 mm {6-5/16"} in diameter. * The hole shape is shown below. Ceiling face ø160 mm {6-5/16"} ø12 mm {1/2"} (4 positions) Template A 4. Install two anchor bolts (M10 recommended) into the concrete ceiling. q Determine the anchor bolt length by use of Template B (accessory). w Position the nut by use of Template B (accessory). (The distance between the bottom surfaces of the ceiling board and nut shall be 136 mm {5-3/8"}. ) Use a nut Anchor bolt Determine the anchor bolt length Template B 136 mm {5-3/8"} Ceiling board Install the anchor bolt in the center of the hole Note: If there is already an anchor bolt installed, the anchor bolt can be used as a second anchor bolt. Make sure that the distance between the 1st and 2nd anchor bolts is 1 000 mm {39-3/8"} or less before use. 6 5. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safety wire (accessory) to the angle. Upper side q Disconnect the safety wire from the Anchor bolt Mark w safety wire angle. w Engage the face marked q with the w Insert e Bend anchor bolt. r Connect the safety wire to the safety wire angle again. Safety wire Mark q Lower side Safety wire angle r Connect Note: To use the anchor bolt that was already installed, the use of 2 spacer nuts is helpful. Spacer nuts Spacer nuts Safety wire Safety wire angle Existing anchor bolt 6. [. . . ] Important: The mark, "FRONT", shall be aligned with the Panasonic logo. Tighten the fixing screw to be used for cover fall prevention. (Recommended tightening torque: 1. 6 N·m {16 kgf·cm}) FRON T FRONT Fixing screw to be used for cover fall prevention Note: When the camera lens is pointed in the horizontal direction, the inner shell interferes with the camera's view, and consequently about upper half of the monitor screen is hidden in the WIDE mode. FRON T 14. Mount the camera mounting plate on the mounting base. [. . . ]