User manual PANASONIC WV-Q152C

[. . . ] Unless the microphone is used, cut the rubber with a nipper or conduct another treatment. <For using the direct ceiling mount bracket for the camera, WV-Q105> NM0806-1096 3TR004562BAA Printed in Japan WV-Q105 (option) Anchor bolt (Procured locally) Safety wire angle (WV-Q105 supplied) Mounting screws (4 pcs. ) WV-Q105 supplied) Preface This bracket is exclusively designed to mount the network camera, DG-NS202, on a wall. The network camera shall be mounted on this bracket after mounting this bracket on a ceiling. [. . . ] · The measures of protection against a fall of the camera shall be taken. Failure to observe this may cause injury. · Do not rub the edges of metal parts with your hand. Failure to observe this may cause injury. · Make sure that the installation area is strong enough to hold the total weight of the camera assembly (approx. · The pull-out strength of the installation area shall be 196 N {20 kgf} or more per 1 screw. If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced or the optional direct ceiling mount bracket for the camera, WV-Q105, shall be used. · Procure 4 screws (M4 or M6) securing the camera mounting bracket (supplied with the camera) according to the material of the installation area. In this case, wood screws and nails should not be used. For mounting a camera on a concrete wall, use an anchor bolt (for M6) or an AY plug bolt (M4 or M6) manufactured by Matsushita Electric Works, Ltd. (Recommended tightening torque M4: 1. 6 N·m {16 kgf·cm}, M6: 5. 0 N·m {51 kgf·cm}) · Avoid installing in the following locations. · Locations where it may get wet from rain or water splash (not only outdoor) · Locations where a chemical agent is used such as a swimming pool · Locations subject to steam and oil smoke such as a kitchen · Locations where radiation or x-ray emissions are produced · Locations where it may be damaged by briny air such as seashores · Locations where the temperature is not within ­10 °C - +50 °C {14 °F- 122 °F}. [. . . ] 1 pc. Safety wire w Mount this bracket on the camera with aligning the projection of the camera mounting bracket with "OPEN" of this bracket. Important: Use caution not to catch the cables. Projection of camera mounting bracket LOCK OPEN LOCK OPEN e Turn this bracket clockwise until the projection of the camera mounting bracket aligns with "LOCK" of this bracket. LOCK OPEN LOCK OPEN LOCK OPEN For U. S. , Canadian and Puerto Rican fields: Panasonic System Solutions Company, Unit Company of Panasonic Corporation of North America Security Systems www. panasonic. com/security For customer support, call 1. 877. 733. 3689 Executive Office: Three Panasonic Way 2H-2, Secaucus, New Jersey 07094 Zone Office Eastern: Three Panasonic Way, Secaucus, New Jersey 07094 Central: 1707 N. [. . . ]