User manual PANASONIC WV-Q168

[. . . ] This ceiling mount bracket is the embedding type so that the camera body will be dwarfed. This bracket is an embedded type to reduce the exposed portion of the camera body. [. . . ] · Do not rub the edges of metal parts with your hand. Failure to observe this may cause injury. · Make sure that the installation area is strong enough to hold the total weight of the camera assembly (approx. 0. 8 kg {1. 76 lbs. }) before installation. · The ceiling mount bracket can be installed only when there is a space whose height is 80 mm or more above a ceiling board. · The ceiling mount bracket can be installed on a ceiling board whose thickness is 30 mm or less. · The camera and the ceiling mount bracket should be fixed using the provided fixing screws, and make sure that the both of them are fixed firmly. · When the ceiling mount bracket is not necessary anymore, remove from the ceiling. · Avoid installing in the following locations. · Locations where it may get wet from rain or water splash (not only outdoor) · Locations where a chemical agent is used such as a swimming pool · Locations subject to steam and oil smoke such as a kitchen · Locations where radiation or x-ray emissions are produced · Locations where it may be damaged by briny air such as seashores · Locations where the temperature is not within ­10 °C to +50 °C {14 °F to 122 °F}. · Locations subject to vibrations (This product is not designed for on-vehicle use. ) · Locations where the temperature may rapidly change such as the peripheral areas of the air outlets of air conditioners or doors facing outside. (In case of installing the camera in such locations, the dome cover may become foggy or condensation may be caused on the cover. ) · The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area. After tightening the screws or bolts, perform visual check to ensure tightening is enough and there is no backlash. Maximum thickness of the ceiling board is 30 mm {1. 18"} for installation. Clamp plates * Clamping screw * Tightening torque: 0. 61 N·m {6. 0 kgf·cm} Clamp the ceiling board. Important: · When the ceiling board is the plasterboard, make sure that no crack was made on the ceiling board by clamping. 4. [. . . ] AF switch push tool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fixing screw (M4 x 8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]