User manual PANASONIC WV-Q2041P

[. . . ] Ilmoitamme yksinomaisella vastuullamme, että tuote, jota tämä ilmoitus koskee, noudattaa seuraavia standardeja tai muita ohjeellisia asiakirjoja, jotka noudattavat direktiivien 73/23/EEC ia 89/336/EEC. Vi erklærer oss alene ansvarlige for at produktet som denne erklæringen gjelder for, er i overensstemmelse med følgende normer eller andre normgivende dokumenter som fælger bestemmelsene i direktiven 73/23/EEC og 89/336/EEC. THIS APPARATUS MUST BE EARTHED. To ensure safe operation the three-pin plug supplied must be inserted only into a standard three-pin power point which is effectively earthed through the normal household wiring. Extension cords used with the equipment must be three-core and be correctly wired to provide connection to earth. [. . . ] · Move the cursor to "CAMERA ID" and press the CAM (SET) button to display the character editing menu. · The character cursor on the letter "A" and the editing cursor on the left end of the editing area starts blinking. · Move the character cursor to the desired letter by using the joystick and then press the CAM (SET) button. The selected letter is written to the editing cursor position. (The blinking editing cursor moves to the right automatically at this moment. ) · Repeat the above procedure until all character editing is completed. · When the position of the editing cursor is to be shifted in the editing area, move the character cursor to "" or "" and press the CAM (SET) button. This function is used to move the editing position or to correct an individual character. · When a blank space is needed, move the character cursor to the "SPACE" position and press the CAM (SET) button. The blank space is inserted into the cursor position in the editing area. · When all characters in the editing area are to be erased, move the character cursor to "RESET" and press the CAM (SET) button. · After completing the editing of the camera Identification characters, the display position of the camera identification characters on the monitor screen can be set as follows. · To mask this area, press the CAM (SET) button. The mask and the cursor start blinking alternately. · To mask other areas, move the cursor to the desired area by using the joystick. Then press the CAM (SET) button to mask that area. · When the cursor is moved to an area that has already been masked, the mask and cursor start blinking alternately. · Press the CAM (SET) button if this masking for this area is to be canceled. · Press the F2 button of WV-CU550A when all masking areas are to be canceled. · After masking is completed, press the CAM (SET) button for more than 2 seconds. The 48 mask areas on the monitor screen disappear and the field setup menu is then displayed. · If the video output level (picture contrast) is to be changed, move the cursor to "LEVEL" and control the joystick to adjust the iris of the ALC lens. When the cursor is moved in the right (+) direction, the lens iris is opened wider, causing the video output level to rise. [. . . ] The cables come from the side Cut the diecast case and decoration cover as shown in the following. Marking Diecast Case Note: Be sure to protect the video and power cables. Otherwise, these cables will be damaged with the cutting surface. Fix the camera mounting angle onto the ceiling by using four camera mounting angle fixing screws (not provided). Caution: Install to support the load of 4 times the total weight. b. [. . . ]