User manual PANASONIC WV-RC150

[. . . ] The wire which is coloured brown must be connected to the terminal in the plug which is marked with the letter L or coloured red. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the top of the unit. [. . . ] Move the cursor to the character you want to change by pressing / / / . The selected character appears in the editing area. (The pointer in the editing area moves to the right automatically at this moment. ) 5. Repeat the steps above until all characters are edited. To enter a blank space in the CAMERA ID Move the cursor to SPACE and press . To edit a specific character in the CAMERA ID 1. Move the cursor to the editing area by pressing . Move the cursor to the CAMERA ID parameter. The cursor on the letter "0" starts blinking. 2. Move the pointer to the character to be edited by pressing or . Then move the cursor to the character area and select a new character. In this mode, even though the backlight may vary, the object at the centre of the screen can be still be clearly seen. Note: If ELC is selected, set LEVEL according to this procedure. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON SENS UP OFF SYNC INT WHITE BAL ATW MOTION DET OFF LENS DRIVE DC END SET UP ENABLE 1. Press after selecting ALC, the ALC CONT menu appears. -22- 2-2. ALC Mode with PRESET OFF ** ALC CONT ** BACK LIGHT COMP PRESET OFF MASK SET LEVEL RET END . . . I. . . . . + These modes are effective when the main object in the scene is not located in the center of the screen and a source of bright light is located near the centre of the screen. In these modes, the picture is divided into 48 corresponding areas mask the light to keep the clarity of the picture. Note: If ELC is selected, set MASK SET and LEVEL according to this procedure. Move the cursor to PRESET parameter and select OFF. The items MASK SET appears on the menu. ** ALC CONT ** BACK LIGHT COMP PRESET ON LEVEL RET END . . . I. . . . . + ** ALC CONT ** BACK LIGHT COMP PRESET OFF MASK SET LEVEL RET END . . . I. . . . . Move the cursor to PRESET parameter and select ON. [. . . ] · It takes about 0. 2 seconds for the alarm signal to reach the alarm terminal of the VTR after the camera detects the object. Because the alarm signal is multiplexed on the video signal, it may be mistakenly interpreted by other video equipment as a time code signal. Therefore, when camera is not used in a Panasonic Intelligent CCTV System select OFF to prevent the above from occurring. 9. Lens Drive Signal Selection (LENS DRIVE) This item is used to select the type of auto iris lens drive signal to be supplied to the lens from the auto iris lens connector. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER OFF AGC ON SENS UP OFF SYNC INT WHITE BAL ATW MOTION DET OFF LENS DRIVE DC END SET UP ENABLE 1. [. . . ]