User manual PANASONIC WV-VF65B

[. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1965 The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the top of the unit. [. . . ] Repeat the steps above until all characters are edited. To enter a blank space in the CAMERA ID Move the cursor to SPACE and press I(S). To replace a specific character in the CAMERA ID 1. Move the cursor to the editing area by pressing I(D). Move the pointer to the character to be replaced by pressing I(L) or I(R). Then move the cursor to the character area and select a new character. To erase all characters in the editing area Move the cursor to RESET and press I(S). All characters in the editing area disappear. To determine the display position of the CAMERA ID 1. Move the cursor to POSI, and press I(S). The display at right appears and the CAMERA ID is highlighted. Synchronization Setting (SYNC) You can select internal sync (INT) mode, line-lock (LL) mode or the VD2 signal (multiplexed vertical drive signal) mode. The priority for the sync modes is as follows: (1) Multiplexed Vertical Drive (VD2) (Highest priority) (2) Line-lock (LL) (3) Internal Sync (INT) (Lowest priority) 2. The line-lock mode has a submenu for line-lock vertical phase adjustment. If the camera installation is relocated, check the vertical phase adjustment again since the AC line phase may be different. 6-1. Move the cursor to SYNC and select ** SYNC ** LL. V PHASE Note: The settings in this menu can be COARSE 1(1--16) made only when the multiplexed vertical drive signal (VD2) is not FINE I. . . . . . . . After confirming that the cursor is on RET END LL, press I(S). The vertical phase adjustment menu appears on the monitor screen. Supply the video output signal of the camera to be adjusted and the reference camera video output signal to a dual-trace oscilloscope. Set the oscilloscope to the vertical rate and expand the vertical sync portion on the oscilloscope. Press I(L) or I(R) to match the 1 (1 - - 16): 0 degrees vertical phase for both video output 2 (1 - - 16): 22. 5 degrees signals as closely as possible. [. . . ] Move the cursor to PUSH SET for PAN/TILT and press I(S). Press I(U) or I(D) I(L) or I(R) to change the angular field of view. To return to the EL-ZOOM setting menu, U ZOOM D press I(S). RET END 9-7 BW This function lets you switch from color to black-and-white picture automatically in low light conditions such as at night. Select AUTO1, AUTO2, ON or OFF using I(L) or I(R). [. . . ]