User manual PANASONIC WX-C1027

[. . . ] KX-TG8151 KX-TG8161 KX-TG8161 KX-TG8161 Handset Part No. KX-TGA816 KX-TGA816 KX-TGA816 KX-TGA816 Quantity 1 1 2 3 R The suffix (E) in the following model numbers will be omitted in these instructions: KX-TG8151E/KX-TG8161E/KX-TG8162E/WX-C1027 Feature differences Series KX-TG8151 series KX-TG8161 series *1 Answering system ­ Intercom Between handsets *1 *1 Single handset models: Intercom calls can be made between handsets by purchasing and registering one or more optional handsets (page 5). Helpline Tel. 0844 844 3899 Ireland 01289 8333 3 TG8151_61E(en)_1220_ver021. pdf 3 2011/12/20 18:50:43 Introduction Accessory information Supplied accessories Quantity No. A B C D E F *1 *2 *3 *4 A Accessory item/Part number AC adaptor/PNLV226EZ Telephone line cord/PNJA1037Z (for U. K. ) Rechargeable batteries*1 Handset cover*2 Belt clip*3 Charger*4 KX-TG8151 KX-TG8161 1 1 2 1 1 ­ KX-TG8162 2 1 4 2 2 1 KX-TG8163 3 1 6 3 3 2 See page 4 for replacement battery information. [. . . ] Turn this feature off if you prefer not to hear key tones while you are dialling or pressing any keys, including confirmation tones and error tones. If you subscribe to a Caller ID service and want to view the caller's information after lifting up the handset to answer a call, turn off this feature. The recall/flash time depends on your telephone exchange or host PBX. To prevent other users from joining your conversations with outside callers, turn this feature on. KX-TG8151 series: page 3 30 Helpline Tel. 0844 844 3899 Ireland 01289 8333 TG8151_61E(en)_1220_ver021. pdf 30 2011/12/20 18:50:47 Programming Special programming Alarm An alarm sounds at the set time for 1 minute and is repeated 5 times at 5 minute intervals (snooze function). A text memo can also be displayed for the alarm. A total of 5 separate alarm times can be programmed for each handset. You can set one of 3 different alarm options (once, daily, or weekly) for each alarm time. Important: R Set the date and time beforehand (page 16). 7 MbN: Select the desired alarm tone. a R We recommend selecting a different ringer tone from the one used for outside calls. 8 9 MbN: Select the desired snooze setting. is 3 aM N Changing the handset name Each handset can be given a customised name ("Bob", "Kitchen", etc. ). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. If you select "Yes" without entering any handset name, "Handset 1" to "Handset 6" is displayed. 4 5 1 2 3 4 5 (middle soft key) #104 Enter the desired name (max. a times M N 2 Changing the start and end time 1 2 (middle soft key) #237 Continue from step 3, "Turning night mode on/off", page 31. Setting the ring delay This setting allows the handset to ring during night mode if the caller waits long enough. After the selected amount of time passes, the handset rings. If you select "No Ringing", the handset never rings during night mode. Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Important: R When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list after the call is (page 36) with disconnected. 1 2 (middle soft key) #239 MbN: Select the desired setting. a aM N Note: R When the answering system answers the call, this feature does not work. [. . . ] Cause/solution R Disconnect the AC adaptor and telephone line cord from the base unit. Remove the batteries from the handset and leave to dry for at least 3 days. After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. [. . . ]