User manual PANASONIC WX-CC2010

[. . . ] Wireless Communication System Center Module Operating Instructions Model No. WX-CC2010 Series ENGLISH POWER VEHICLE PRESENT Digital Technology WX-CC TRAN 2010 SCEIV MONIT ER OR WX -C T2 02 0 Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. FRANÇAIS A B ENGLISH VERSION FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Continuous Transmission On/Off Switch (CONTINUES, ON/OFF) This switch should be normally set to OFF. ON: When the switch is set to ON, the transmission starts by turning on the power of center module. OFF: When the switch is set to OFF, the transmission starts with the following conditions. · The VEHICLE DETECTOR switch has been set to NORMAL or OVERRIDE ON. · The button P or T on the order taker unit has been pressed. USA/Canada Switch (USA/CANADA, USA/CND) To select a radio frequency suitable for the region, set this switch as follows. USA: This setting is available in the United States. CND: This setting is available in Canada. Talkback Level Control Switch (T/B LEVEL: TBC1, TBC2, ON/OFF) These switches are used for the talkback level setting of the order taker unit. Change the settings if the talkback level is too high. Talkback Level ­6 dB ­9 dB ­12 dB ­ Setting TBC1 TBC2 TBC1 TBC2 TBC1 TBC2 TBC1 TBC2 Remarks Normally set to this position. Talkback is off. Note: These settings are activated when the DNR switch is set to Low, Normal and High. DNR (Digital Noise Reduction) Effect Level Control Switch (DNR EFFECT: DNR1, DNR2, DNR3, ON/OFF) These switches are used for the noise reduction level setting. The more the noise is reduced, the lower the sound quality will be. The following table shows the relationship between noise reduction level and sound quality. Note: No setting should be done other than shown in the table. Noise Reduction Level Sound Quality Setting DNR1 DNR2 DNR3 DNR1 DNR2 DNR3 DNR1 DNR2 DNR3 DNR1 DNR2 DNR3 Remarks No DNR processing Low High For a relatively quiet environment For a general environment This setting is recommended. For a very noisy environment Not recommended because it affects sound quality. Normal Normal High Low 9 w Vehicle Detector Normal/Override On/Off Switches (VEHICLE DETECTOR, NORMAL/OVERRIDE ON/OFF) NORMAL: The vehicle detector turns on only when a vehicle is detected at the menu board. When the detector is turned on, a beep tone is heard in the headset. After the beep tone, the menuboard speaker turns on to allow the communication with the customer. When the vehicle leaves, the vehicle detector turns off. OVERRIDE ON: The vehicle detector is always turned on. OFF: Vehicles are not detected at the menuboard. No beep tone is heard in the headset, and the menuboard speaker remains off. e Channel Group Selection Switch (CH SELECT, 1 to 8) This switch selects the group from 8 positions. [. . . ] · Push the CIRCUIT PROTECTOR button. 10. ) · Refer to the dealer or qualified service personnel. · Is the CH SELECT switch set to 1 to 8?· If the problem remains even after trying the above, refer to the dealer or service personnel. [. . . ]