User manual PANASONIC WX-CH2050

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party: Contact Source: Matsushita Electric Corporation of America 1707 N. 60123 Panasonic Consumer Electronics Company 866-472-6767 CAUTION It is a violation of Federal Law to begin operating this system prior to obtaining an FCC Radio License. The FCC ID number for this radio equipment is listed below. [. . . ] Rotate and bend the microphone boom so that the microphone is placed near your mouth. VOL. A/B 6. Press the power button to turn on the headset. Install a battery in the battery compartment, referring to BATTERY LOADING & REPLACEMENT. VOL. A/B q w e 6 Communications with Customers [TALK] Any store personnel wearing the headset can communicate bidirectionally with any customer who is at the menu board. Select a proper sound level by pressing the [] or [] button. Communications with Other Store Personnel [PAGE] Store personnel wearing the headset can communicate with each other without being heard by customers. <When the page-lock mode is preset> 1. Press the page [P] button and speak into the microphone at a normal level. A short beep repeats in the headset to notify all store personnel that the system operates in the page mode. VOL 2. You will hear a tone in the headset when a vehicle arrives at the menu board. Note: The tone duration varies depending on the settings made in the center module. Press 2. Press the page [P] button again to release the lock and listen to the response from other store personnel. <When the talk-lock mode is preset> 1. Press the talk [T] button and speak to the customer. A short beep repeats in the headset. Press again Press <When the press-to-talk mode is preset> 1. Cannot hear or talk to the customer, while communications with the store personnel are OK. The vehicle detector may malfunction because it is not plugged into the center module, no power is supplied, or the detecting function is out of order. Radio wave intensity is insufficient in the areas. Cannot "page" or "talk" in certain areas. Remove any metal obstacles blocking radio waves, or extend the transmission antennas. Turn off the units one by one while listening to the beep. You can identify the faulty unit through the process of the elimination of the units. Consult your dealer for repairs. A constant beep is always heard in the headset when the "page" or "talk" button is pressed. The "page" or "talk" button on one of the units may be kept depressed. SPECIFICATIONS Operating Frequency: Type of Radio Wave: Required Power Supply: Control Function: UHF/FM F3E Rechargeable Li-ion Battery, 3. 7 VDC, normal type or long life type Power (On/Off) Volume (Up/Down) Talk Page Channel Selection (A/B) Channel Group Selection (1-8) DIP Switch Setup (8 bit) 140 mm(W) x 240 mm(H) x 84 mm (D) 5-1/2" (W) x 9-7/16" (H) x 3-5/16" (D) 160 g (0. 35 lbs) Dimensions: Weight (excluding battery): STANDARD ACCESSORIES Windproof Cushion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Strap. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Miniature Screwdriver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 OPTIONAL ACCESSORIES Long Life Battery (Li-ion 3. 7 VDC, 1 500 mA/h). . . . . . . . . . . . . . . . 2050BAT Standard Battery (Li-ion 3. 7 VDC, 1 035 mA/h) . . . . . . . . . . . . . . . . 2051BAT Battery Charger. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2050CH 9 SETUP PROCEDURES Caution: Setup of this product should only be performed by qualified service personnel or system installers. Opening the Switch Pocket 1. [. . . ] Select a default channel setup from four options, pressing the [T] button. Press the [A/B] button to move to the talk setup and page setup. Select a talk mode, pressing the [T] button. Select a page mode, pressing the [P] button. [. . . ]