User manual PANASONIC WX-RP810

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. [. . . ] Turn the power off and have the unit examined by qualified service personnel. Do not expose the center module or order taker unit to rain or moisture, or attempt to operate the equipment in wet areas. Do not operate the equipment if it is wet. Follow normal safety precautions to avoid personal injury. Properly store the order taker unit (WITH HEADSET PLUGGED IN) in the order taker unit case to prevent damage to equipment. Replace a missing microphone cover and ear speaker cover of the headset with a new one to prevent distortion or loss of audio. Repair or replace any defective components. Turn off the order taker unit when not in use, in order to save the battery life. When the power indicator lights up in red and a pulsing beep tone is heard in the headset, charge battery to the order taker unit (if using WX-CT2020 in combination with WX-C1027A) or all-in-one headset (if using WXCH2050A). Clean the battery charger of the order taker unit or allin-one headset in accordance with manufacturer instructions at least once a month. (Refer to the operating instructions of the battery charger. ) 12. t Power On/Off Switch (POWER, ON/OFF) This switch turns the power of the center module on and off. Channel Monitor Channel Monitor is the mode to check if other devices have already used the desired channel at the time of the installation. The following is how to activate Channel Monitor. When you set the POWER switch to ON while holding down the O/T TALK LOCK RELEASE switch, Channel Monitor is activated. To return to the default mode, turn off and on the power again with the POWER switch. y Talk/Page Indicator (TRANSCEIVER MONITOR, Red/ Green/Amber) Red: · When the order taker unit is in the Talk Communication, the indicator lights up in red. · When an error happens, the indicator always blinks in red. Green: When the order taker unit is in the Page Communication, the indicator lights up in green. Amber: When the gooseneck microphone is enabled, the indicator lights up in amber. u Power Indicator (POWER) (Green) This indicates that the power of center module is on. i Vehicle Detector Indicator (VEHICLE PRESENT) (Amber) This indicates that a vehicle has been detected. o Menuboard Speaker Volume Control (MENU SP, 0 to 10) This control sets the output level of Menuboard Speaker to the optimum level for speaking to the customer. [. . . ] To prevent fire or electrical shock, the UL listed power supply cord (Style SVT) should be used for the cable for 12 V AC terminal. #6 Input Cord A pigtail cord is provided for the speaker input. #7 Mounting Bracket AU-type mounting bracket with screw holes is provided as a standard accessory with the WX-C550. Antenna Standard Accessory · Mount the antenna. WX-CC 2010 TRAN SCEIV MONIT ER OR ULTRAPEX II DNR POWER POWER Memo Label Standard Accessory VEHICLE PRESENT VEHICLE PRESENT A · Write down DIP switch settings if necessary. B 12 OPERATING PROCEDURES Refer to WX-CT2020/WX-CH2050A Operating Instructions for details. COMPATIBILITY WX-RP810 and WX-C1020 When PAGE is pressed during the TALK LOCK function is activated, the TALK LOCK function is canceled and PAGE sound comes out of the menu board. TROUBLESHOOTING Problem The communication between the order taker units and menu board cannot be established. (The TRANSCEIVER MONITOR indicator is not blinking in red. ) Check item · Is the POWER switch on the center module turned on?10. ) · Check the AC power outlet. [. . . ]