User manual PARKINSON COWAN 1154565

[. . . ] · The appliance must be installed according to the · Ensure that the vents at the top of the oven are instructions supplied. The installation work must not obstructed to ensure ventilation of the oven be undertaken by a competent person as stated cavity. in the Gas Safety (Installation & Use) · Never line any part of the appliance with foil. For appliances · Do not allow heatproof cooking material, e. g. [. . . ] Crown to body (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the two longer location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. Cap to crown Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. Check for ignition If a burner will not light then you need to check the crown and cap positions. CLEANING THE HOB The hotplate Clean the hotplate top using a mild abrasive such as 'Cif'. Take care not to damage the spark electrodes. If the spark electrodes are damaged the burners will not light. You can remove the pan supports, burner caps and burner crowns to clean them. Aerosol cleaners must not be used on the Stayclean surfaces and must not come into contact with the elements or the door seal as this may cause damage. CARE OF STAYCLEAN SURFACES CLEANING THE PLATED HANDLES (Where Applicable) It is strongly recommended that only hot soapy water is used for cleaning the handles. ANY OTHER CLEANING MATERIALS WILL DULL THE SURFACE FINISH. Stayclean surfaces destroy splashes of food and fats when the oven temperature is raised to around 220°C. It is a good idea to run the oven for an hour or two per week to ensure continued good performance from the Stayclean finish. 20 HINTS AND TIPS CLEANING THE DOOR GLASS To prevent damaging or weakening the door glass panels avoid the use of the following: · Household detergents and bleaches · Impregnated pads unsuitable for nonstick saucepans · Brillo/Ajax pads or steel wool pads · Chemical oven pads or aerosols · Rust removers · Bath/Sink stain removers · Manual cleaning of the Stayclean surfaces IS NOT recommended. Damage will occur if abrasives or aerosol sprays of any kind are used. Slight discolouration and polishing of the Stayclean surfaces may occur in time. This DOES NOT affect the Stayclean properties in any way. A good time to allow the oven to run on is after the weekly roast. After removing the roast, turn the oven up to 220°C and allow to run for an hour or so. It is important NOT to allow a buildup of soilage as this can prevent the Stayclean surfaces from working. Follow the recommendations below to keep oven soilage to a minimum. [. . . ] Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig. Assemble upper bracket to lower bracket so that the underside of bracket is dimension 'C' + 3mm above floor level. 4b) Reposition appliance and check that top bracket engages into appliance back as shown in Fig. 4b. 487mm (B) (C) 100mm (A) 300mm Fig. 4b. [. . . ]