User manual PARKINSON COWAN CSIM509X

[. . . ] INSTRUCTION BOOKLET GB MIXED FUEL COOKER CSIM 509 Please read this instruction booklet before using the appliance Important Safety Information You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950 Installation l l l l l l This cooker must be installed by qualified personnel, according to the manufacturers instructions and to the relevant British Standards. Any gas installation must be carried out by a registered CORGI installer. Remove all packaging before using the cooker. [. . . ] Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Clean the outer and inner door glass using warm soapy water. Should the inner door glass become heavily soiled it is recommended that a cleaning product such as Hob Brite, or Bar Keepers Friend is used. DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Force Centre who will be pleased to advise further. External cleaning Regularly wipe over the control panel, oven door and door seal using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. To prevent damaging or weakening the door glass panels avoid the use of the following: Household detergent and bleaches Impregnated pads unsuitable for non-stick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers 11 Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. If the soilage has become set, after the oven has cooled down, the following process will help to soften the splatters to help make cleaning easier. F 1. Place the grill/ meat pan on the oven shelf positioned in the lowest runner. Add a few drops of washing-up liquid to the pan and fill to about 12 mm. Close the oven door, turn the oven function knob on fan oven on 50°C. After 15 minutes, turn off the thermostat and allow the fan oven to continue without heat for a further 5 minutes, when the temperature of the water will have cooled down. Carefully remove the pan of water from the oven and use normal oven cleaners to clean away soil residues. Leave a little of the soapy water to soak into any burned on spillage on the floor of the oven for a longer time if necessary. Oven Shelves To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. Oven lamp replacement Disconnect the appliance. Unscrew the lamp and substitute it with another suitable for higher temperature (300°C) having the following characteristics: Voltage: Power: Connection: 230-240V (50Hz) 15W E14 FO 0424 12 Something Not Working If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM SOLUTION n There is no spark when lighting the gas u Check that the unit is plugged in and the electrical supply is switched on u Check that the RCCB has not tripped (if fitted) u Check the mains fuse has not blown u Check the burner cap and crown have been replaced correctly, e. g. u Check the burner cap and crown have been replaced correctly, e. g. [. . . ] C. 1 F Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow. Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter 'N' or coloured black. Connect the brown (live) wire to the terminal in the plug which is marked with the letter 'L' or coloured red. NOTE: The earth wire should be about 2 cm. [. . . ]