User manual PARKINSON COWAN L55GX2WL

[. . . ] Read the booklet thoroughly before you use the appliance. Keep the booklet in a safe place so that anyone who uses the appliance can read it. Pass the booklet on with the appliance if you give or sell it to someone else. For your safety This appliance is not intended to be operated by means of an external timer or separate remote control system. The appliance is designed for domestic use to cook food. [. . . ] After cleaning the appliance parts, dry them thoroughly before you put them back. g ni n a el c d n a er a C When replacing hotplate burner parts 1. Crown to body (Do not try to force the crown on to the body). Make sure that the hole in the crown is centrally over the electrode. Check that the two longer location pegs sit in the slots in the body. When the crown is in the position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. Cap to crown Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is fitted properly. Check for ignition If a burner will not light then you need to check the crown and cap positions. The grill Do not clean the grill burner itself. The burner is designed to be self cleaning. Cleaning the grill may cause the holes in the burner to become blocked preventing it from operating correctly. If you do not do this, the door glass could fall forward. 4 Using both hands, gently tilt the top of the door glass towards you. Lift it slightly to disengage the locators at the bottom of the door. Please note that the door glass on your product may differ in type and shape from that shown in the diagram. 5 Clean the glass using hot soapy water and mild abrasives such as 'Cif'. DO NOT try to clean the foil which is inside the door. The foil is there to help keep the door cool, if it is damaged it will not work. 6 Replace the glass by holding it in both hands and gently placing the locators into the holes of the brackets at the bottom of the door. Push the top of the glass towards the oven door, and make sure the screw location holes line up. 7 Hold the glass in place with one hand and replace the cross head screws into the location holes, with the other hand. Give the screws one turn to make sure the glass is held in place. 8 Tighten the screws using a pozidrive screwdriver. Close the door. 22 LYRIC 55GS1 n iot lal at s nI Cleaning The Door Glass To prevent damaging or weakening the door glass panels avoid the use of the following: Household detergents and bleaches Impregnated pads unsuitable for non-stick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. [. . . ] Remove oven burner box retaining clips (one spring clip from each side) and remove box front cover. Replace one clip back into the right hand side of the burner box. Remove oven burner by removing the spring clip from the right hand side of the oven burner and slide the burner off the injector whilst easing it towards the front of the appliance, taking care not to strain the F. S. D. Connect the pressure gauge to the oven injector. [. . . ]