User manual PARKINSON COWAN SG305BL

[. . . ] SG 305 Operating and Installation Instructions n iot c u d or t In SG 3 0 5 Introduction This gas appliance has been designed and manufactured to all the necessary British Standards. The appliance complies with European Council Directive 90/396/EEC. It is important that you understand how to use and care for the appliance properly before you use it for the first time. We have written this booklet with your safety in mind. [. . . ] Again take care not to damage the spark electrodes. If any food spills during cooking you can place the pan on another burner to finish cooking. Then you can remove the dirty parts and clean them before the spill 'burns on'. 20 You can wash the removable parts in very hot soapy water. Make sure that the electrode and the hole and slots in the crown are not blocked with food or cleaning materials. Clean the burner crowns by soaking them in very hot soapy water. You can remove any stubborn stains by scouring with a soap filled pad such as 'Brillo'. If you look after the burner crowns in this way they will stay reasonably clean. However the surface will dull with time. Aluminium based saucepans can leave shiny metal marks on the pan supports. Clean the pan supports regularly to remove the marks using a mild abrasive like 'Cif' with a soft scourer. For more stubborn marks you can use a soap-filled pad such as 'Brillo'. After cleaning the appliance parts, dry them thoroughly before you put them back. When replacing hotplate burner parts 1. Crown to body (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the two longer location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. Cap to crown Place cap centrally on the top of the crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. Check for ignition If a burner will not light then you need to check the crown and cap positions. 21 Care and cleaning SG 305 Care and cleaning SG 305 The grill Do not clean the grill burner itself. The burner is designed to be self cleaning. Cleaning the grill may cause the holes in the burner to become blocked preventing it from operating correctly. [. . . ] Check the supply pressure by turning the thermostat on and one hotplate tap full on and light the appropriate burner. The pressure should be either:(i) For Natural Gas 20mbar (ii) For LP. Gas The pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane. Turn off the taps, disconnect the pressure gauge and replace oven burner and cover, ensuring that the F. S. D. phial is correctly located into the bracket on the burner. [. . . ]