User manual PARKSIDE AIR STAPLER SET

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. Fastener driving tool safety Safety at work . The following pictograms are used in these operating instructions / on the device: Read the operating instructions!Always heed warning labels and safety instructions! [. . . ] Always use a threaded plug-in nipple ¼`` and a quick release coupling for the compressed air connection. Never place your hands near the opening while the device is ready to operate. Check the device for damage before bringing it into use. Do not use the device if you discover any defects. Never poke pointed and/or metal objects into the interior of the device. Never exceed the maximum allowable working air pressure of 7 bar. Use a pressure reducer to set the working air pressure. Never use oxygen or other combustible gas as the energy source. Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents. Keep children and other people away while you are operating the fastener driving tool. Distractions can cause you to lose control of the device. Remain alert at all times, watch what you are doing and always proceed with caution when working with the fastener driving tool. Do not use the fastener driving tool if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the fastener driving tool can lead to serious injury. The use of driven fasteners or accessories other than those recommended in the operating instructions could lead to you suffering an injury. NOTE: Operate the compressed air tacker only with cleaned, oiled compressed air and never exceed the maximum working air pressure at the device of A pressure reducer must be fitted to the compressor to regulate the working air pressure. Connect the other end of the compressed air hose to the (filter) / pressure reducer at the compressor. NOTE: Never place nails into the intermediate opening; this opening is intended for staples. Otherwise this could lead to a blockage in the driver and prevent the proper exit of the driven fastener. NOTE: Note that only staples with a length of 16 - 32 mm and nails with a length of 15 - 32 mm may be placed in the magazine. Load the magazine 6 of the compressed air tacker, as described in the section about "Loading the magazine". [. . . ] Manual lubrication NOTE: If you do not have an oil mist lubricator, you must lubricate the device before each period of use and/or after long periods of disuse. J Place 3 - 5 drops of compresses air special oil into the threaded plug-in nipple 4 of the compressed air tacker. j Then press the trigger 2 a few times. J Introduce 5 - 10 drops after a period of disuse of more than 5 days. [. . . ]