User manual PARKSIDE AIR TOOL SET

[. . . ] Please make sure you familiarise yourself fully with the way the device works before you use it for the first time and that you understand how to handle the device correctly. To help you do this please read the accompanying operating instructions. Keep these instructions in a safe place. If you pass the device on to anyone else, please ensure that you also pass on all the documentation. [. . . ] Keep children and other people away while you are operating the device. Distractions can cause you to lose control of the device. Disconnect the device from the compressed air source before carrying out any repairs or maintenance of the device or moving it to another location. When removing the hose coupling, hold the hose tightly in your hand to avoid injury caused by the hose shooting backwards. Check the device for damage before bringing it into use. Do not use the device if you discover any defects. J Do not kink the device's hose, otherwise you may damage it. The use of accessories other than those recommended in the operating instructions could lead to you being in danger of injury. NOTE: Operate the product only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 8 bar. NOTE: The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. Often used on mountain bikes) Read off the filling pressure on the gauge 1 . If the object is overfilled with air (air pressure too high): Press the deflator valve 3 to release some air. Press the lever of the valve connector 5 downwards and pull the valve connector 5 off the valve. After you finish work, disconnect the device from the compressor. NOTE: First disconnect the hose from the compressor and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around in an uncontrolled manner. Using accessories: j Press the lever of the valve connector 5 and insert the desired accessory 10 to 13 or the cap 9 into the valve connector 5 . Using the blow gun Screw an extension nozzle 8 on to the blow gun 7 . After you finish work, disconnect the device from the compressor. NOTE: First disconnect the hose from the compressor and only then disconnect the compressed air supply hose from the device. [. . . ] The appliance is intended solely for private, not commercial, use. If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. This warranty does not affect your statutory rights. Contact your local refuse disposal authority for more details of how to dispose of your worn out electrical devices. [. . . ]