User manual PARKSIDE KH 3040 AIR SANDBLASTING GUN

[. . . ] We will not accept liability for loss or damage arising from improper use. The device is intended for private, domestic use only. 1 Air sandblasting gun 1 Operating instructions 1 Valve set (for use with a compressor) 3 ­ 8 bar 130 ­ 260 l / min 2, 8 mm 1000 ml Cleaned and oil-free Working air pressure setting at the pressure reducer max. Working pressure: Recommended working air pressure: Compressed air consumption: Nozzle ø: Container capacity: Required air quality: Working settings: Read all the safety advice and instructions. [. . . ] J ensure that the spent blast medium is trapped and collected so that it can be disposed of in an environmentally compatible manner. NOTe: Operate the air sandblasting gun 1 only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 8 bar. NOTe: The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. J Connect the air sandblasting gun to a suitable compressed air source by connecting the quick-release coupling of the air supply hose with the plug-in nipple 3 to the air sandblasting gun 1 . Ground blast furnace slag) with a grading of 0. Ensure that the blast medium is completely dry and not too coarse. Pull the blast medium container 4 off downwards. Fill the blast medium container 4 with the desired amount of blast medium. ensure that the maximum capacity of the container (1000 ml) is not exceeded. Screw the blast medium container 4 back on and lock it in place by inserting and turning it on to the container lid (see Figs. J Always use a suitable blast medium for your sand blasting work. Using the air sandblasting gun (see Figs. J Carefully prepare the workpiece before sand blasting it. J Carefully mask or tape off everything that is not to be sand blasted. J Ensure that there is always a minimum distance of 20 cm between the air sandblasting gun 1 and the surface being sand blasted. J After you finish work, disconnect the device from the compressed air source. NOTe: First disconnect the hose from the compressed air source and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around in an uncontrolled manner. [. . . ] This warranty applies only to the initial purchaser and is non-transferable. The warranty covers only material or manufacturing faults, not normal wear or damage to fragile parts such as switches or rechargeable batteries. The appliance is intended solely for private, not commercial, use. If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. [. . . ]