User manual PARKSIDE KH 3143 2-SPEED HAMMER ACTION DRILL

[. . . ] Any other use or modification to the tool shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. Please make sure you familiarise yourself fully with the way the tool works before you use it for the first time and that you understand how to handle electrical power tools correctly. Further details can be found in the operating instructions. [. . . ] J o not work in areas where there may be D hidden electricity cables or gas or water pipes. Use a suitable detector or ask your local utility service providers. Contact with electricity cables can lead to fire or electric shock. Of a water pipe can lead to property damage or to electric shock. To avoid the risk of injury: Wear protective glasses, hearing protection (noise can lead to hearing loss), dust protection mask and protective gloves. Please note that working on stone or metal can give rise to hazardous dusts that can adversely affect your health. J e particularly careful when screwing in longer B screws - the driver could slip off the screw head. This is much safer than holding it in your hand and it means you then have both hands free to operate the electrical power tool. J J J J J If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Never use the device for a purpose for which it was not intended. Before you insert the mains plug into the socket, always check that the device is switched off. When taking a break from your work, before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket. Handle the device carefully and treat it with respect. Always keep the device clean, dry and free of oil or grease. Always watch what you are doing and proceed with caution. Do not use the device if you cannot concentrate or you are feeling unwell. J ou will require a suitable bit holder if you wish Y to use screwdriver bits with the drill. The screwdriver bits used must be match the screw head. For reasons of safety, this device must be used only with the auxiliary handle 8 in place and properly attached. It is essential that you note the following: if the drill becomes jammed, a very large torque can be generated (, , the force that the machine will exert to rotate about its own shaft"). This will help you to drill to the exact depth required. Devices marked with 230 V can also be operated at 220 V. [. . . ] J o not allow any liquids to enter the device. J o not under any circumstances use petrol or D strong solvents. The gear selector switch must only be moved after the drill has come to a standstill. J elect between the following speed ranges S using the gear selector switch 7 : 1 = low speed range 2 = high speed range Do not dispose of electrical tools with household rubbish! [. . . ]