User manual PARKSIDE KH 3177 ANGLE GRINDER

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. Page Careful handling and use of electrical power tools . Page Safety advice relating specifically to this device . The following pictogrammes / symbols are used in these operating instructions: Read the operating instructions! [. . . ] Always work with the mains lead leading away from the rear of the device. J Grinding discs must be carefully kept and handled in accordance with the manufacturer's instructions. J Make sure that abrasive consumables and tools are attached in accordance with the manufacturer's instructions and advice. J Ensure that any spacers supplied or required for the use of certain abrasive consumables and tools are properly installed. J Before you use the device make sure that the abrasive consumable or tool is correctly attached and firmly fastened in place. Allow the tool to run under no-load conditions for 30 seconds in a safe position. Stop the device immediately if a significant amount of vibration occurs or if any defects are found. in this event check over the machine to find the cause of the problem. J Never use the electrical power tool without its disc guard cover, if it was supplied with one. J When using abrasive consumables and tools with a threaded insert make sure that the threaded hole is long enough for the spindle length. J Do not work in areas where there may be concealed electricity cables or gas or water pipes. Use a suitable detector or ask your local utility service providers. Contact with electricity cables can lead to fire or electric shock. damaging a gas pipe can lead to an explosion. Penetration of a water pipe can lead to property damage or to electric shock. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the working area. Wear hearing protection, protective glasses, a dust protection mask and protective gloves. J For longer periods of cutting or grinding wood, metal or stone materials that give rise to dusts that are hazardous to health, connect the device to a suitable external vacuum dust extraction device. J Connect a suitable vacuum dust extraction device when you are working on stone or masonry. The vacuum dust extraction device must be one approved for use with stone dusts. Machining metal can result in electrically conductive dust being deposited inside the device. [. . . ] Switching on continuous operation mode j Press the safety lock-out 3 and keep it pressed. Press the ON / OFF switch 2 in the area of the safety lock-out until the latter locks. Switching off continuous operation mode: j Press and then release the ON / OFF switch 2 Rotating the hand grip j Pull the mains plug out of the mains socket before you carry out any task on the device. j The hand grip 1 can be rotated by 90° to the right or left. [. . . ]