User manual PARKSIDE PABS 10.8 A2

[. . . ] Keep children away from electrical power tools!Check that the device, mains lead and plug are in good condition!Before you use it for the first time, it is essential that you make yourself fully familiar with the functions of the appliance and find out how to correctly handle electrically powered tools. Read the following directions for use as well as the safety instructions. [. . . ] If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. The use of these devices reduces the hazard presented by dust. Careful handling and use of electrical power tools a) Do not overload the device. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. B) Do not use an electrical power tool if its switch is defective. A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. General safety advice for electrical power tools Tool that can no longer be switched on and off is dangerous and must be repaired. Pull the mains plug out of the socket and / or remove the rechargeable battery before you make any adjustments to the device, change accessories or when the device is put away. Seek additional medical help if any of the fluid gets into your eyes. Escaping battery fluid may cause skin irritation or burns. A workpiece held in a clamp or vice is kept more securely in place than one held by your hand. Harmful / noxious dusts generated from your work represent a risk to the health of the person operating the device and to anyone near the work area. Do not drill any material containing asbestos. High reaction torques may occur momentarily during tightening or loosening of screws. If the inserted tool jams, switch off the electrical power tool immediately. Be prepared for high reaction torques as they may cause kickback. The inserted tool may jam if the electrical power tool is overloaded or is held at an angle to the workpiece. Use and handling of the cordless electrical power tool A) Charge a rechargeable battery unit using only the charger recommended by the manufacturer. General safety advice for electrical power tools / Before first use wARNING! [. . . ] Press the rotational direction switch 5 into the middle position. You can use the torque control / drill step 11 to adjust the torque. when the value of the torque setting is reached , the clutch disengages the drive connection to the chuck. Select a low setting for small screws, soft work material. [. . . ]