User manual PARKSIDE PBSG 95 A1

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the    device. Page 23 Device-specific safety instructions for drill sharpeners. Page 27 GB 21 Introduction The following pictograms are used in these operating instructions / on the device: Read instruction manual!Wear hearing protection, dust protection mask, protective glasses and protective gloves. [. . . ]  void unintentionally starting up the A device.  heck that the switch is set to OFF on the deC vice when the mains plug is inserted into the mains socket.  sing an extension lead for working U outdoors.  hen working outside, always use an approved W and appropriately labelled extension lead. Do not use electrical power tools if you cannot concentrate.  heck the electrical power tool for C damage.  efore the electrical power tool is used, carefully B check the safety equipment and any slightly damaged parts to see that they are still working properly.  heck that all moving parts on the tool are C working properly, can move freely and are not 24 GB damaged. All parts must be correctly attached and fulfil all the requirements necessary to allow the electrical power tool to operate properly.  amaged safety equipment and components D must be properly repaired or replaced at a competent electrical equipment repair centre unless otherwise indicated in the operating instructions.  amaged switches must be replaced at a D Customer Service Centre.  ever use an electrical power tool that cannot N be switched on and off properly.  he use of inserted tools and accessories other T than those recommended by the manufacturer could lead to you being injured.  ave your electrical power tool H repaired at an electrical equipment repair specialist.  his electrical power tool complies with the T relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. Device-specific safety instructions for drill sharpeners  ake sure that the device is switched M off before inserting the mains plug into the socket.  lways pull the mains plug out before A carry out cleaning or maintenance work. This is to prevent the device starting up by accident.  he ventilation openings 10 of the moT tor unit must always be kept clear. Otherwise there is a risk of the device overheating.  hen carrying out work on the device W as well as transporting or storing it, move the ON / OFF switch 4 to the “0” position (off) in order to prevent it switching itself on by accident. [. . . ] Before you carry out any work on the device, always pull the mains plug out of the mains socket. Replace the sharpening stone if it is worn out or damaged (deteriorating, irregular sharpening performance, broken stone). a Phillips screwdriver is required for this step.  crew the four screws 3 out of the sharpening S head cover 2 and remove the cover 2 , refer to Fig. [. . . ]